Your cart is empty.
Your cart is empty.Product Description
Stainless Steel Horizontal Centrifugal Pump & Motor
- Reliable single stage or multistage impeller designs
- All stainless steel wet end construction for reliability
- Able to pump hot water up to 158°F
- Carbon/Ceramic mechanical seal for reliable operation
- Higher than normal 120°F ambient temperature rating
- High operating temperature and high current draw protection
- Robust TEFC motor constructed from corrosion resistant materials
- IP55 international protection rating for dust and dirt
- Permanently split capacitor for reliable starting
- Motor and pump are designed for frequent starts
Torrium 2 Controller
- Larger water pathway provides superior hydraulic performanceAd
- aptive starting - monitors incoming pressureQu
- ick cut-in for constant flow and even water pressureEx
- tra Draw off Capacity w/ Built In AccumulatorEa
- sy status check LED'sDr
- y run protection with auto restartHi
- gh Water Temp, Excessive Electrical Current and Power Surge ProtectionCo
- rrosion & Scale ResistanceVe
- rtical/horizontal 360° dischargePo
- wer Cable - 6 ft power cord with standard NEMA power plug
Choose from five different models with varying performance curves for most any application
Hydraulic Performance is the amount of pressure boost the pump will add to your incoming pressure at a specific flow rate. Select the best pump for your application based upon your existing incoming pressure and desired combined system pressure (Usually < 80 psi to meet local building codes.) Model / Voltage / Incoming Pressure Range
- BT14-30 / 120V / 22-60 psi Incoming Pressure
- BT14-45 / 120V / 2-40 psi Incoming Pressure
- BT20-30 / 120V / 10-50 psi Incoming Pressure
- BT20-40 / 240V / 0-20 psi Incoming Pressure
- BT30-30 / 240V / 10-50 psi Incoming Pressure
Note: Do not exceed a Maximum System Pressure of 100 psi (incoming pressure PLUS pump boost).
david
Reviewed in the United States on July 11, 2023
I replaced a Davey Pump that had been in operation for fifteen years and it probably could have gone longer but I wanted to upgrade to the newer pump. We have been using the BT20-40T2 pump assembly for the last two years and it has worked flawlessly. I highly recommend this Davey Pump Purchased in 2021.
Danny
Reviewed in the United States on September 10, 2022
I installed this pump right right after the well pump and immediately water pressure to house up 20-30 psi pressure. I installed this pump to give more pressure to my sprinkler system for around house
Hollie
Reviewed in the United States on February 12, 2022
Love the pump! I was a little alarmed when I saw how small it is but it out performed my expectations! You will need a pressure regulator! Great product!
Blake L.
Reviewed in the United States on November 27, 2021
Long story short, I had some install issues and couldn't figure it out. The seller, Primo Pumps, helped me as best they could for about 5 days until we finally discovered the install error and I got it fixed. I have a solar well pump that feeds into two 2500 gallon tanks and gravity brings it to the house. Our old pressure tank and pump gave out and decided to try one of these new pumps out. I have more pressure in our 2700sqft, 2 story house than we have had since we bought the place. Hopefully the pump lasts.
Larry
Reviewed in the United States on September 13, 2020
I did a lot of homework before purchasing the Davey pump. Lots of review not on this website and also looked at international users (the pump is Australian made). Overwhelming general consent is the pump is reliable for 10+ years of service and well made.So, I purchased this pump to deliver potable water from our water well holding tanks to the ranch at 80psig. Install was really simple and the pump worked flawlessly for 5 days. Then it failed to start one morning and indicated an electrical Fault via the panel light indicator. Called supplier since you know who disavows any knowledge of anything once they have your money. Supplier informs me the pump warranty will fix or replace, all I have to do is ship it back to them on my nickle and wait 2-3 weeks to process. Shipping will run me $180. That is 30% of what the pump cost. The pump and motor are fine, I believe the $50 motor start capacitor has failed since the pump powered and hummed but would not spin and the shaft turns easily and smoothly. Supplier won't send me a new capacitor under warranty. So I purchased a new capacitor myself (cheaper than shipping) and voila! Pumps works great.Message here is the pump seems to be well made and is very simple to set up and operate. The warranty is useless. So if you purchase the pump do so as though its all up to you to keep the thing running; because it is.I recommend the pump and the supplier's tech support over the phone was great. Just don't expect a warranty that means anything.
joel r. bachman
Reviewed in the United States on May 8, 2020
Very unhappy with the product, Motor under powered! Then they don’t tell you upfront there’s at least a 20% restocking fee if you return it, and if anything is missing out of the product they charge you a 50% restocking fee!!!
Adam S. Borz
Reviewed in the United States on June 3, 2017
Wow this thing really works, way better than the cheaper HF one I bought. I have to get another pressure regulator after the pump to turn down the outlet pressure. It is making my hot water heater pressure relief drip.
Scott Weiant
Reviewed in the United States on February 22, 2015
Once i got it installed it worked great. The problem was i did not know i needed a 15 Amp outlet. I even called the dealer first and they said it was a regular plug. That is what my previous pump used.
Recommended Products
$122.37
$ 60 .99 $60.99