Your cart is empty.
Your cart is empty.Belt AX 1/2 x 41in OC.
Murphblast
Reviewed in the United States on March 12, 2025
Just as good as oem. One third the cost.
Lonesome Dove
Reviewed in the United States on August 23, 2024
As described, perfect fit
Don b
Reviewed in the United States on March 24, 2024
Exact fit for my table sander
carlos arturo zurita lopez
Reviewed in the United States on September 15, 2023
Same as top brand, works on mi variable speed drill
David C.
Reviewed in the United States on August 22, 2023
Fits my dad's old model 113 2988020 perfectly. Note: If you have one of these and have not changed the belt on a table saw before. The tensioners can be slightly adjusted to straighten out the angle of the belt so it is straight. I tensioned it a little tight, then tightened the bolt on the right just short of completely locked. Then I used a scrap hard board and a mallet to strike in the left tension bar in enough to line up the belt so it was straight on the pully and not angling to the right a little. And then tightened down everything. It should make the belt it last longer.It stopped the vibration I was getting from the old worn out belt. If you have one of these, keep it! They really don't build them like they used to. I cut several precision cuts for speaker cabinets and they were spot on with a good Diablo blade.
martin weber
Reviewed in the United States on April 14, 2022
their number system stinks
Kei
Reviewed in the United States on October 6, 2021
Works great. Put on a restored 1939 Delta drill press. Does better than the link belts I use on my saw and jointer that tension by motor weight. This belt is great for applications with fixed pulleys.
geezer11
Reviewed in the United States on April 27, 2021
Installed spring 2012. So far no defects have developed. Jury is still out so 4 stars at 20 hours use
Recommended Products
