EKDP
Reviewed in the United States on April 27, 2023
Unit is not accurate at all, it's rated to handle 60L/minute and is unable to be accurate even at 20-40L/minute. Overshoots 20-50% with high irregularity so can't even adjust K value to compensate.
Farhad
Reviewed in Canada on September 18, 2022
It doesn’t show the real flow rate of water. The number is around two times more than real flow rate.Temprature sensor works good!
Durwood M. Dugger
Reviewed in the United States on November 2, 2022
In this day and age, not having a wireless report of flow rates and the ability to control an emergency shut off valve - makes this produce very limited. Essentially, its a volumetric sprinkler controller.
Jblank
Reviewed in the United States on January 16, 2022
Working perfectly to check flow rate on a UV sterilizer attached to my saltwater reef aquarium.I didn't need to use the solenoid valve only the flow meter and thermometer, both worked perfectly and were easy to set up/install. Most difficult thing is setting the proper "K-Value" for accurate flow rate.
Richard Curtis
Reviewed in Canada on January 7, 2021
Arrived on time and well packaged. Be aware that the thread is British pipe and connectors are hard to find. I used FIP fitting with an added washer and no leaks so far. Early step in set up is to set the K value of the sensor and they do not tell what the K value is of the included sensor. I have messaged them today and am waiting for an answer. The instructions say to contact the manufacturer for the K value, they are the manufacturer so why do they not provide the information that they know you will need.
Kaitlynn
Reviewed in the United States on September 27, 2020
Flow sensor lasted about two weeks and stopped reading.
chamurai
Reviewed in Japan on September 11, 2020
フローセンサだけ使用してます。常に1.3~1.5mpaの圧力のかかるところで少し使用してみましたが、1.5mpaぐらいになると使用した量が合わなくなる気がします。とはいえなかなかの圧ですので、逆にいえばそこまでなら安定して使えます。漏れのような少量は検知できないようです。接続は12v直流で使用してますが電源を切るとログが消えます。ログを残したい場合電池式のほうが良さそう。
Jim Warren
Reviewed in the United States on December 24, 2020
Missing the "1 meter adapter cable" to tie the parts together. Guess I'll return the unit and see if I can get a replacement. I'll up the rating to four stars due to very fast replacement. I haven't had time to test it yet, but the equipment looks well made for the price. I have a habit of losing these little instruction books, I wish they would post a PDF copy on line.
Tom S.
Reviewed in the United States on July 16, 2019
I checked this out at home before taking it out to the airfield where I planned to use it to control loading of ballast water into my sailplane. At that time I found out that the pump control output was dead. I have not yet investigated a warranty claim, but I got a simple dc timer to do the same job.
miguel b.
Reviewed in Canada on October 10, 2019
Works as expected and very easy to install very helpful if you want to control water flow.