Your cart is empty.
Your cart is empty. This Disc Brake Mounting Bracket to fit your specific brake caliper to a specific fork.
Package Included:
1 * Adapter
2 * Bolts
2 * Spacer
Gerald Keever
Reviewed in the United States on March 16, 2025
I had a 160 mm hydraulic disk brakes on a 29 inch bike and I wanted a little more bite in the front brakes. The 160 mm disk would lock up the the rear tire no problem, but 160 mm disk felt under-powered in the front. I got a 180 mm disk for the front and this mounting bracket lined up the caliper with the disk perfectly. After bedding the pads and rotor, the 180 mm disk felt great compared to the 160 mm disk.
Mark Z
Reviewed in the United States on January 17, 2025
Just what I needed
Boomer
Reviewed in the United States on December 11, 2024
Since it arrived in nice packaging with the hardware included, it was a breeze to install the only issue I’ve had so far is the fact that I lost a bolt because my wheels were imbalanced. Thankfully, I went to the local bike shop and picked up a couple new bolts with some lock washers.
figuy
Reviewed in the United States on April 24, 2024
The mounting holes are not even close to being centered.
Isaac Morris
Reviewed in the United States on August 16, 2023
I used these on my Vsett 10+ electric scooter to upgrade to 160mm rotors, great fit!
skip
Reviewed in the United States on September 4, 2022
Direct fit, NO OTHER PARTS TO BUY
Alan
Reviewed in the United States on September 28, 2022
Good quality and they work great!
Josh S.
Reviewed in the United States on July 29, 2022
It's hard to give something like this a bad review unless it's defective from the beginning. It holds the brake caliper.
Recommended Products
