Your cart is empty.
Your cart is empty.Stainless Steel Scuba Wrench Set Curved handles and 4 of the most commonly requested wrench sizes for scuba air hose attachment and general equipment maintenance. sizes include 1/2,” 9/16,” 5/8,” and 11/16″.
Scott Sexton
Reviewed in the United States on July 6, 2022
Rusted almost immediately upon contact with salt water.
David R.
Reviewed in the United States on November 23, 2022
not for long... but it works and it is built strong IMHO
George Zamora
Reviewed in the United States on November 19, 2022
You need this in your save the dive kit. Fit is snug on sizing, requires some shimmering, but gets the job done well. Would purchase again
TX-morejunkmiles
Reviewed in the United States on October 20, 2022
Great in a pinch for swapping out regs and hoses, but will chew up the nuts on your 1st and second stages. Plus metal is soft. Just don't use them ALL the time. Get a better tool for regular use. I keep a set in my save a dive kit.
Murphy K.
Reviewed in the United States on October 19, 2022
I bought this product specifically for the wrench pictured with a 5/8" opening on one end and a 9/16" opening on the other. (This combo allows me to put a single wrench in my travel kit.) When they arrived, I discovered that the wrenches are actually 5/8"-1/2" and 9/16"-11/16".Fortunately I was able to open up the 1/2" jaw using a mill, but anyone without access to machining equipment will not be able to purchase the one-wrench solution that I expected when I chose this product.
roger coss
Reviewed in the United States on October 22, 2021
Scuba diving, work great, And don’t over tighten your crap
A. Sychev
Reviewed in the United States on December 1, 2020
Minimal but sturdy and imperial sizes are right for most standard regulator hoses.
Juan Arango
Reviewed in the United States on November 29, 2020
Great set of wrenches if you need to call nnwct and disconnect hoses from your gear
Recommended Products
