Your cart is empty.
Your cart is empty.Product Description
Customer
Reviewed in the United States on February 7, 2025
Everything works on the bench right when I closed up my project it didn't work. It powers on and off every 5 seconds for no reason ,n powers on and off for no reasonWasted 4 hours of my evening Thanks.
Fred
Reviewed in the United States on September 18, 2024
4 amps is ok but pushing it. Very thin wires and NO way this can handle 40 amps... It shuts down at 5 amps on a 7.2vdc battery... These are crap. A waste of my time and money.
anthony santos jr
Reviewed in the United States on September 12, 2024
I like the shipping time line.
Pooleboy
Reviewed in the United States on August 28, 2024
No external heat sink, heat trapped inside plastic housing, poor design, will fail 100% of the time with the rated load.
Chad Hiob
Reviewed in Canada on September 8, 2023
They worked as described. As a bonus, I needed to salvage some of the connections for another project so I opened up one of the two to desoldered the wires and guess what I found? All the electronics that were supposed to be there, not sure what the other reviewer was talking about.
Paul Rodgers
Reviewed in the United States on July 13, 2023
I used a pair of these to drive 2 12v brushed motors (3s lipo), these motors are about 65watt, 12000rpm. They pull 5 or 6 amps each, ran OK on the bench.Installed into the R/C tank, 2 breakers at 7A eachIt will not run more than a few seconds, does not pop the breakers,so my guess is that they are good for about 3 amps at most.
J Weir
Reviewed in Canada on June 29, 2023
I made a R/C 8inch duck. On the workbench it seemed to work acceptably. Put it a tub or out to the pond and the rudder would go hard to port with any throttle applied. Yes the throttle worked ok. I tried all the standard noise suppression methods to no avail. If I held the receiver about 10inches above the duck while in water (tub) it mostly worked ok. I found an older speed control in my junk box and it worked perfectly. I bought 2 - 2 packs , , , tried 2 - junked all 4. Serves me right for buying cheap speed controls.
stanleydecastro
Reviewed in the United States on January 2, 2023
The media could not be loaded.
Customer
Reviewed in Canada on December 9, 2022
Bought the 2 pack so I can use them for a tank drive. 280 motors that pull about 2A each.One doesn't do anything at all.The other worked for about 10 seconds and then let out some smoke. It appears to be the BEC that smoked, even though the only thing connected was a servo tester. It then worked for about 2 min when powered with an external BEC, now it only runs one direction. Pretty disappointed that they don't work.
john s
Reviewed in the United States on December 5, 2022
Nice simple esc for projects
Customer Review
Reviewed in the United States on December 21, 2022
Who remembers the old reostat style speed controls you had to drive with a servo? i do!Brushed motors aren’t as in as they used to be in the RC word. Everything has gone brushless. But these are great small speed controls for robots, R/C boats and smaller R/C tank applications that still use brushed motors.Would recommend for the price if you are building a small skid steering robot and want an easy interface between your MCU or Raspi and brushed motors.
Recommended Products
$137.95
$ 62 .99 $62.99