Shopping Cart

Your cart is empty.

Your cart is empty.

DMA Video Overlay Box -Compatible Video Processor + Stark 75T DMA Board + KMBOX NET Version DIY Kit US Plug

5.0 Write Review
Free shipping on orders over $29.99

$224.89

$ 99 .00 $99.00

In Stock
  • Situations where an upgrade is It requires adding an EDID. As following: First Step: Read the monitor EDID; Method: Connect the GPU of the computer host to the main monitor using an -compatible2.0 or -compatible2.1 cable (very important: it is the output of the GPU, directly connected to the main display without going through the DMA video overlay box).
  • After opening, select the serial port number (if the serial port number is not correct, it point out fail), select the correct injection location in the parameter injection (according to the resolution of the main monitor, which is the resolution set above, it is very important to choose the correct resolution), select the injection method as [Load Parameter File], select the parameter file (the saved Bin file read before), and finally click [Injection Parameters] to wait for injection.
  • On the computer host, select the most suitable GPU output resolution and refresh rate (such as 2560x1440 at 144, 1920x1080 at 240, etc.) to enable the monitor to display normally. Then install the MonitorAssetManager with the file name of mi_setup.exe. After installing, run the Monlnfo.exe and wait for it to open.
  • Second Step: inject EDID to the DMA video overlay box - After saving the Bin file, insert the Type-C cable into the Type-C port of the DMA video overlay box, and connect the other end of the USB to the computer where the Bin file was just saved. (At this point, restore the normal wiring of the DMA video overlay box, that is, connect the -compatible output cable of the computer host GPU to , and connect output cable to the main monitor.) Power it on, and then turn on .
  • During the injection process, a black screen appear for a while, and after completion, there be a prompt indicating successful injection. After successful injection, unplug the Type-C cable and keep the output of connected to the -compatible cable to the main display.


Ruitutedianzi Precaution:Using the previously set refresh rate for the host and secondary computers, right-click on the desktop to open "Display Settings", check if the resolution is correct, drag to the bottom to open "Advanced Display Settings", select the monitor (the model is you just injected), and set the refresh rate below to the optimal refresh rate for your monitor.
Note:Due to different product batches, the appearance , which does not affect the use.
Plug Type:US Plug, it applies to Canada, India, Mexico, Thailand, Taiwan, the , the Philippines and so on.
Voltage:AC110V
Colour:As Shown
Material:Plastic+Metal
Package Contents:
1 * DMA Video Overlay Box Kit
Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.