Your cart is empty.
Your cart is empty.Since 1918, we have been the automotive aftermarket’s pioneering problem solvers. We have released thousands of parts and components that people could once only buy from original equipment manufacturers. By always innovating, we have led the way in growing the aftermarket, providing more opportunity to individuals and businesses who depend on automotive maintenance. That’s why our catalog includes more than 80,000 products and grows every year.
Stephen the Ex-Monk
Reviewed in the United States on November 6, 2024
Wheelstuds. Can't get much simpler.My use case was the spare tire hanger I just bought for my trailer. It came with metric bolts and I wanted to have the same thread pitch and diameter to match the trailer axle.It does. The lugnuts I already had go right on.I won't complain.You will need to press them into place, Amazon has a number of tools for that purpose. You could also drive them in with a hammer and punch, or do like I did and use a hydraulic press.
Tai D.
Reviewed in the United States on April 15, 2024
Product as described and worked well for my 2001 Jeep Wrangler.
Starr
Reviewed in the United States on August 14, 2023
Fits my 2000 Jeep Grand Cherokee no problem upon installation
Customer
Reviewed in the United States on November 19, 2020
Worked great on my Jepp TJ.
PJM
Reviewed in the United States on November 17, 2020
Easy to install, just use an old two piece wheel nut upside down
J. Gray
Reviewed in the United States on July 24, 2019
Just what it’s supposed to be
Jake Hitzfield
Reviewed in the United States on July 8, 2016
Fit tight, but perfectly. Replaced bent studs on a 02 Jeep Wrangler. I bought these studs because they were long, I got exactly what my vehicle needed.
K-Web
Reviewed in the United States on May 4, 2016
At least for me, It did not work good. How ever it does fit a Jeep XJ 2000 sport wheel stud. I tried to install them using the Old washer and nut method. The first stud started to push in, but slowly became a stand still. I removed the Nut and I noticed that all of the threads on the stud were pulled back from the pressure. I thought maybe it was my fault. So I removed and put the second stud in and started to ratchet. The stud went in pretty smooth. When i went to pull off the nut, I noticed immediately something was not right. The threads once again pulled back =( The nut was not stuck on, and would not back fully off. I had to air ratchet and hammer off. So I gave up, I am sure they would work great if properly installed using a tool. Threads can not stand up to the pressure of installing.
Recommended Products
