Your cart is empty.
Your cart is empty.This replacement HVAC heater hose assembly is engineered to match the fit and durability of the stock heater hose assembly on specified vehicles. It is designed to withstand extreme temperature changes to extend service life. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Buick Rendezvous: 2002, 2003, 2004, 2005] - [Chevrolet Venture: 2000, 2001, 2002, 2003, 2004, 2005] - [Oldsmobile Silhouette: 2000, 2001, 2002, 2003, 2004] - [Pontiac Aztek: 2001, 2002, 2003, 2004, 2005] - [Pontiac Montana: 2000, 2001, 2002, 2003, 2004, 2005]
michael clark
Reviewed in the United States on October 9, 2022
So in the past I have purchased exhaust manifolds that were miss machine and doorman knew about it. This time this hose or tube as it should be called has a major flaw. When you install it as it should be the small tubes that go to the throttlebody cooler hoses are darn near touching the exhaust crossover which makes it impossible to get the small rubber hoses onto them. Plus with it being too close I would be afraid that it would melt the rubber hoses so I definitely returned it. It looks like for this particular part you would be better off going and getting a factory one or a good used one
Customer
Reviewed in the United States on August 27, 2020
was suppose to be new part was used...sent it back was refunded
Steve Jirsa
Reviewed in the United States on January 31, 2019
Fit was not good, Heather hose end was slightly larger so quick connect wouldn't slide over. Two ports above exhaust manifold were welded in the wrong direction and bracket was welded almost 1/2" short of where it shoulda been to match OEM. No way to even bend/modify it to fit. Waste of time.
Wanda
Reviewed in the United States on July 11, 2018
The hose was nice easy to install no problem on that good fit. The problem I had was the bleeder screw kept leaking antifreeze up kept trying different sealants tapes and everything to get it to stop the little drip. So I took my old hoes took the bleeder screw off of that put it on this new one and it stopped leaking.
Love2horseplay
Reviewed in the United States on June 23, 2018
Just what I needed
Judy fluck
Reviewed in the United States on August 3, 2017
it said it was for my car and would fit. had to spend 3 hours bending it to be the right angle.very disappointed had to pay exgra for labor
chef34
Reviewed in the United States on March 26, 2016
It wasn't OEM as stated, had some issues getting it to fit in correctly. But is installed and working as it should.. Just be ready for some slight modifications and have a second set of hands on stand by as you will need them.
Customer
Reviewed in the United States on October 28, 2014
This hose assy did not fit as it arrived. The tubing was 50 thousands oversize making it too large to fit into the quick connector going to the heater core. As we were in a bind we cut the end off the old assy and used a section of rubber hose and clamps to make it fit. After mounting it we started the motor and found that the welds at the bleeder were leaking along with the section where the bleeder fits.
Recommended Products
$22.37
$ 9 .99 $9.99
$373.07
$ 99 .00 $99.00