Your cart is empty.
Your cart is empty.Diesel engine idling rough, misfiring or stalling? This replacement injector control pressure sensor matches the fit and function of the original equipment sensor to ensure the control module receives accurate information for smooth running.
Joe Usher
Reviewed in the United States on March 9, 2024
The wires are just barely long enough to work 1 slip up and you have a mess.
Bobbi
Reviewed in the United States on July 31, 2023
Just replaced it yesterday. Install wasnt as bad as some people made it seem. My truck has had a weird idle for a while and recently started surging/stalling when it threw a P2285. Fired right up, code cleared and now it runs better than ever.
Mark
Reviewed in Canada on June 29, 2023
Happy with product, no complaints
Arthur. John Mcdermott
Reviewed in Canada on February 1, 2023
I was shipped a used one that did not work.Not amused pics take
Jcopton
Reviewed in Canada on April 28, 2023
It’s says 2 packBut only recieved 1 sensor 1 wire?????
HS
Reviewed in Canada on June 23, 2022
Installed it in the vehicle by a mechanic. Waiting to see if it was the issue. No negative or possible comment at this time.
Dan
Reviewed in the United States on April 27, 2022
Says 2 pack in description, received only 1.
Red
Reviewed in the United States on July 20, 2020
Lasted approximately 1.5 years and blew out at the beginning of our family vacation towing an RV. Had to tow the truck and rent a truck. Dorman sensor cost nearly a thousand dollars. Stick with genuine Ford sensors.
John P Kelly
Reviewed in the United States on October 7, 2020
This sensor works in my '04 F250 / 6.0 Diesel. It is a different size (slightly bigger, different wrench size) but screwed in and sealed. BEWARE; disregard the wire colors on the supplied "pigtail." Be SURE you trace each wire from each location on back of plug, same as the original. The wire colors were close, but I found two terminals reversed on the plug they sent me. Final note; NO INSTRUCTIONS came with it!
Joe R.
Reviewed in the United States on June 8, 2018
Failed in first 100 miles and about emptied the engine oil. I use many Dorman products, but this one, as many aftermarket IPC sensors, misses the mark.
John T
Reviewed in the United States on January 25, 2018
Fit my 2003 early 6.0. This sensor comes with the pigtail too. 3 heat shrink crimp splices are already attached too. I ordered the pigtail separately but Amazon did a free return. Replacing this sensor is a real challenge though.
Recommended Products
$75.00
$ 35 .99 $35.99
$42.62
$ 18 .99 $18.99