Your cart is empty.
Your cart is empty.Protect the braking system from debris and corrosive weather conditions with this rust-resistant replacement brake dust shield. Dimensional verification and salt spray testing ensures proper fit and extended service life. Vehicle model years this part fits (be sure to check your vehicle trim using the Amazon garage) - [Chevrolet Blazer: 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005] - [Chevrolet S10: 1998, 1999, 2000, 2001, 2002, 2003, 2004] - [GMC Jimmy: 1997, 1998, 1999, 2000, 2001] - [GMC Sonoma: 1998, 1999, 2000, 2001, 2002, 2003, 2004] - [Oldsmobile Bravada: 1997, 1998, 1999, 2000, 2001]
Jimmy
Reviewed in Canada on June 18, 2024
Very happy with quality and fitment. Great value
Christopher P.
Reviewed in the United States on November 3, 2024
These are trash. The cheap retaining screw snapped off when I put moderate torque on it. I spent hours getting the broken shank out. I re-used the original screw with no problem. I do not recommend these at all unless you want to have the same problem.
adrien
Reviewed in Canada on October 23, 2024
bien
steven michael steven
Reviewed in Canada on January 16, 2024
Perfect fit on an '03 GMC Jimmy with the disc calipers and drum parking brake (for the rear brakes). Great product
Will
Reviewed in Canada on August 22, 2023
product came is great condition, fits like factory and have a nice corrosion resistant black coating, would recommend 👌
D Taylor
Reviewed in the United Kingdom on August 11, 2023
qualitys not bads or fitment for aftermarket
david
Reviewed in the United States on March 25, 2023
Good part.
Doug Heyns
Reviewed in the United States on November 7, 2023
Great fit and well made. I had to cut them apart at the brake caliber mount location so I didn't have to pull the axles out.
blh
Reviewed in the United States on June 14, 2022
Dorman comes up with many parts to fit DEFECTIVE equipment usually with simple and impressive solutions, however this AIN'T ONE of them! I can tell your the dust shield has to fit pretty precisely as it is supposed to fit in a groove of the Rotor with out touching which would make a 2 piece design tougher but Dorman is supposed to be the problem solvers right?! Even a thicker sheet metal would have been a great improvement.*** This dust shield requires you to remove the axles which it the nightmare Dorman HAS considered in their other 2 piece designs, but not here.PS. I'm slicing mine in half myself. My dust shields have rotted completely away (GM Junk) so this will bea CHEAP better than nothing fix...
Ronnie Meredith
Reviewed in the United States on March 14, 2022
fit perfect same quality as auto store
Chris Easter
Reviewed in the United States on November 7, 2021
Had these installed and worked great
Joe
Reviewed in the United States on January 10, 2020
These are not easy to install. They should be two pieces, but if you're careful you can cut them and slide them on rather than pull the axles...it will save you lots of time!
Chezzycat
Reviewed in the United States on November 29, 2016
Had to bend them a little because the brake rotor rubbed a little. Painted them with an extra coat of black because my old ones were rusted away so bad there wasn't much left of them.
Recommended Products
