Shopping Cart

Your cart is empty.

Your cart is empty.

Dorman 926-140 Rear Passenger Side Pre-Pressed Rear Axle Compatible with Select Toyota Models (OE FIX)

4.6 (2) Write Review
Free shipping on orders over $29.99

$426.11

$ 99 .00 $99.00

In Stock

About this item

  • Easier installation - this loaded axle assembly includes a pre-assembled new axle shaft, wheel bearing, hub and backing plate
  • Time saver - eliminates frustrating, unpredictable work required to replace bearings without damaging other components
  • Simpler solution - eliminates the need to use potentially dangerous shop press to perform complete bearing repair
  • Quality tested - this part has undergone try-on, corrosion and material testing to ensure a quality fit and long service life
  • Ensure fit - to make sure this part fits your exact vehicle, input your make, model and trim level into the garage tool


Replacing a worn wheel bearing usually requires a time-consuming procedure with a shop press. This Dorman OE FIX loaded axle includes all critical components already assembled for a fast, simple, safe install. Vehicle model years this part fits (be sure to check your vehicle trim using the Amazon garage) - [Toyota Tacoma: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015]


George S.
Reviewed in the United States on June 16, 2024
Haven't used yet, good quality for the money
S. Mayo
Reviewed in the United States on May 5, 2024
Came well-packaged, even though the box was damaged, no damage to axle or backing plate. Hardest part was re-assembling the brakes ;-( . I like that the kit came with a new seal and o-ring. I replaced the driver's side bearing/axle 20K miles ago, by same vendor. That bearing is still quiet. I expect the same from this bearing. BTW, both original bearings showed signs of water intrusion (emulsified grease), which led to the bearing failure at 130-150K. I have discovered that water gets into the bearing cavity through the ABS sensor. The o-ring seal around it fails and allows water in. Be sure to replace and lube this little seal when re-installing the sensor! A little silicone around it would not hurt, either.