Your cart is empty.
Your cart is empty.Product Description
Sean
Reviewed in the United States on March 29, 2025
It's decently sticky and easy enough to remove. Will pull paint off walls. It's like electrical tape with glue on both sides, stretchy so it's hard to tear off clean. Works ok for CNC stuff but not my favorite.
Customer
Reviewed in the United States on March 28, 2025
Strong grip, easy to use. I have used for template routing and it felt safe
Llpark
Reviewed in the United States on March 22, 2025
Very strong adhesive but still able to remove it from a newly sealed piece of wood without marring the surface, with a little patience. Great for holding stencils in place or for templates.
BillSenior
Reviewed in the United States on March 16, 2025
Very nice product, probably buy again
A & M
Reviewed in the United States on February 4, 2025
Love this tape. I've tried quite a few. Some are too sticky and leave a residue and some aren't sticky enough and just don't hold. This one is just right. It holds well and leaves no residue
Shilo500
Reviewed in the United States on April 7, 2025
Awesome choice on my part!I make a lot of plywood templet projects for artist wife & this tape has never failed in holding projects together for my ROUTER Table.Easy to separate when done using razor knife.Highly recommend for all projects
Snoopy of Santa fe Springs, CA
Reviewed in the United States on April 5, 2025
As a professional fabricator of more than 46 years, I have always used double sided masking tape to secure fixtures while using a high-speed router and has always been sufficient. However, I didn't have any when I needed it. So, I tried this product and found that it was incredibly strong! A little too strong for my needs. However, if you are looking for a secure grip, this is what you want to use.
Evan
Reviewed in the United States on October 22, 2024
Works very well, it's extremely thin for holding wood projects tightly together while joining pieces together. I originally purchased to used on my table saw sled runners holding it square until I could fasten them in with screws. Worked great! Then I had a lot left over so I used strips to hold drawer faces onto the drawer getting then lined up and spaced evenly so I could then get them fastened on permanently.
Recommended Products