Shopping Cart

Your cart is empty.

Your cart is empty.

Drill America 11/16' X 1' Carbide Tipped Annular Cutter with Pilot, CTC Series

4.8 (7) Write Review
Free shipping on orders over $29.99

$47.91

$ 21 .99 $21.99

In Stock

1.Size:7/8


2.:1 Depth Of Cut


About this item

  • Annular cutters are designed for fast, efficient hole making and cut only that material necessary to produce a quality hole.
  • 3/4" Weldon shank features a round shank with one of more flats machined into the side for easy indexing and alignment. Fits most magnetic drill presses.
  • Carbide tip allows for fast drilling of larger diameter holes with longer life and the ability to perform in more abrasive and harder materials than high speed cutters
  • Pilot pin included.
  • For use with magnetic drill press only. Do not use with a standard hand drill or drill press


Drill America Carbide Tipped Annular Cutters are designed for fast, efficient hole making and cut only that material necessary to produce a quality hole. The carbide tips allows for fast drilling of larger diameter holes with longer life and the ability to perform in more abrasive and harder materials than high speed cutters. Sometimes called mag drills or magnetic drill bits, Drill America Annular cutters have a 3/4" Weldon Shank for use with magnetic drill press only. Do not use this cutter with a standard hand drill or drill press. Pilot pin included.


Mark
Reviewed in the United States on April 24, 2024
Fast cutting. Minimal heat.
Gloria
Reviewed in the United States on July 7, 2023
Don't know what is expected but I was able to get about 28 holes cored through 1/2" mild steel before the cutter gave up. A magnetic drill along with cutting fluid was used. I was hoping for better results.
Bigbazooze
Reviewed in the United States on May 10, 2023
Did the job no problem
sneek
Reviewed in the United States on July 22, 2022
I am happily surprised this bit work well for work project this past weekend
Brewer
Reviewed in the United States on May 1, 2022
While this is a perfectly adequate HSS annular cutter, I paid for a carbide tipped cutter. This is a ground (no carbide tips brazed on) HSS cutter. If I wanted that I would've bought one for less money.I did drill 14 holes in 1" mild steel no problem but the product received is not the product advertised.
Joe the Boss
Reviewed in the United States on July 22, 2019
Carbide teeth sintered into a seemingly well made dimensionally accurate drill bit. 9/16" diameter drill bit, fed through 1" thick mild steel plate for a table mounted vice. We used a Hougen magnetic base drill. Motor oil was used as cutting fluid. All the carbide teeth broke off at only ½" to 5/8" depth within 30 seconds. My next selection will be a bit comprised of high speed steel, same price.
Maksim Smouzh
Reviewed in the United States on June 22, 2018
Please read description. You get carbide tipped cutter, not HSS as in the picture.