Your cart is empty.
Your cart is empty.Product Description
Heavy-duty Steel
Crafted from heavy-duty steel, our engine stand offers a reliable platform with a 1000 lbs capacity, ensuring secure support during maintenance.
Complete Storage Solution
The storage hardware is included with the engine stand, ensuring that you always have the necessary bolts for assembly, no chance to lost bolts.
Easy to Move
Equipped with 3” steel casters that swivel 360-degrees, our engine stand offers easy maneuverability.
User-friendly Design
Pre-drilled holes streamline setup, saving you time and effort so you can focus on the task at hand.
usmcgunny
Reviewed in the United States on March 25, 2024
Not manufactured correctly to line up with motor mount holes. Dowel holes need to be drilled out as well. Plan on putting some time into it to make it fit
Phillip Cadieux
Reviewed in the United States on December 27, 2024
Put together in minutes, holds engine well. Maneuvers with a load easily.
Gearhead Girl
Reviewed in the United States on April 12, 2024
I ordered this--and then didn't get my engine project going for five years. Pulled it out of the box today and found the parts aren't welded right. The bolt holes are off by inches--and don't line up. One side is welded so it is lower and twisted. This thing is a complete mess and totally un-useable. Clearly quality control is non-existent. I would return it, but it's been years...
Mike S.
Reviewed in the United States on September 17, 2023
Pretty decent piece but it does require a little work to use. A couple of the holes didn't exactly line up and the holes for the block dowel pins were too small. No big deal if you have a file or die grinder and bit. The wheels allow you to move your engine around easily. One more thing, the bolts supplied to bolt the frame together aren't up to the task IMHO. I used 5/16 nuts & bolts.
Roland torres
Reviewed in the United States on December 29, 2023
The stand mounting holes did not lined up well with the Ford engine mounting. I had to loosen some of the stand bolts to manipulate the stand hole to line up with the engine. Not safe with several hundred pounds of engine already on a rolling stand! Word of Caution get some help to do this.
michael m missett
Reviewed in the United States on November 27, 2020
Casters had little nubs that i has to smooth out to get it to roll. Casters started to bend and bearing were falling out. The bracket that attaches to the motor mount needed to be notched in order to put the motor on it. Cheap, poor quality.
Troy Gardner
Reviewed in the United States on April 21, 2020
The stand went together nicely, but it was too narrow for a 351w SBF. Holes for rear dowel pins had to be reamed out, and motor mount bolt holes do not line up well, and again, had to be reamed out. It was a tight fit, but I eventually got the stand bolted to the block. The cross member that came with the stand is too narrow, by about 1/2 inch, so I had to use thread all and make my own cross members. The bolts that came with the stand are all metric, so you will have to source standard threaded bolts (7/16 x 14 for application) in order for it to work.Rather than send it back, I chose to modify it to fit my application. Returns are a pain anywhere for anything, so it was just easier this way, plus I needed something that would work immediately. I hope this helps! ;-)
a109598
Reviewed in the United States on December 18, 2019
great item for storing motors easy to move around
Recommended Products