Your cart is empty.
Your cart is empty.David Dickinson
Reviewed in the United States on February 17, 2025
These are yellow. Not whiteThe square ones they sell are white.Too late to take it out now put it all together just to be disappointed
Kevin & Valerie
Reviewed in the United States on April 25, 2024
When looking for a flat small, yet very power LED white light that you want to use with original light covers and your working with a small amout of room, the factory lights were not just extremely small, but wired into the board on which I want to replace. these are the ones, just remove the old school bulbs and all its small barely can see wire. No soldering required. I didn't want to get a new screen, however after I upgraded all my lightsin my TRK to LED and removed the covers on my overhead monitor they were insanely small. (not plug and play for my overhead screen) these bright white Led small lights were the answer. works like OEM only way better. Justthe right brightness, yet not the blinding bright. they come with self strong adhesive on the backs, looks like my overhead screen came factory this way. the lights arent just a small dot, they fill the entire lens again as if these bulbs came already installed in the overhead monitor OEM out of the box. Best part these LED lights matched the ones I previous installed elsewhere thoughtout my Hummer. now my customzied Hummer H2 interior looks prefect.
kr
Reviewed in the United States on April 17, 2024
Used these in my footwells and very pleased
Rick W.
Reviewed in Canada on July 22, 2023
Started out bright. Went dim within 10 minutes, started flickering and all burned out soon after.I’m an electrical engineer. So I got my magnifying lens out and had a good look at them. The say - 2630 9V - on them! 2630 refers to the type of SMD LED and 9V refers to - well 9V! These are made for 9V, not the advertised 12V. There's a 330 ohm resistor on the board, which is correct for a 9V supply, but for a 12V supply that resistor would need to be 480 ohms. What that means is that they are supplying far too high of a voltage and far too much current to the poor little 2630 LED's, which fries them.I could swap the 330 ohm resistor on each for a 480, but they're all fried now at this point and I'm fed up with this supplier.So ridiculous that they advertise them as 12V and all they had to do to achieve that was put a different resistor on the circuit board. Nothing else needed to change.Garbage.
TheOne
Reviewed in the United States on February 3, 2020
These are bright, small and easy to install. The adapters like most others fit almost all cars. Nothing to complain.
A Fan
Reviewed in the United States on December 26, 2020
These LED's didn't last a week. I used them for my car door light and around the 5-6th day they started to flicker one by one and they stop working. Simple to install if you have the know-how with cars. Overall I might have gotten a defective product and my experience with them might been the same with other people who review this item and other may have a product that actually work.
Daniel Contreras
Reviewed in the United States on December 12, 2020
They would be great if they all worked fine. But unfortunately one burnt out and two more are barely bright and not glowing that much. So not sure if the others will even last. If they do, then it will be more quality control issues and hit or miss if all that you order will work.
Aaron
Reviewed in the United States on March 8, 2019
The solder pads are incredibly small, and lift very easily. The COBs themselves are bright, definitely a cool white. But if you need to replace the super thin wires that come with, you are outta luck. All six of mine went in recycling, sadly.
Bruce Aungst
Reviewed in the United States on December 10, 2018
I inserted pictures which show the incandescent bulb in the dome light fixture compared to the replacement LED unit. Very simple to replace., The light quality is amazing and the heat inside the lens is much less with the LED than the incandescent filament type bulb.I like everything about this kit. Low cost, great light output. SImple to swap out. If you want brighter lights inside your vehicle, this is likely the way to achieve it. I used these in the dome lights of a John Deere 1025R Mauser cab and the results are simply amazing. I also had enough in the kit to change 4 other interior lights to LED. Excellent deal and works just as they said they would.To be honest, they should charge more for the results this kit produced for under $9
patel harish
Reviewed in Canada on October 29, 2017
nice bright light ..
Recommended Products