Your cart is empty.
Your cart is empty.Fluke current clamps are the ideal tools to extend the current ranges of Fluke tools. The i200s is a dual range 20A and 200A ac current clamp with voltage output via a safety insulated BNC connector. A dual banana to BNC adapter is supplied to allow the i200s to be connected to multimeters with banana inputs. Companion to your ScopeMeter, power quality meter or digital multimeter to measure up to 200A AC. Included adapter for DMM's. Two ranges: 20 A and 200A, 10 or 100 mV/ Amp output. Take accurate current readings without breaking the circuit. Maximum conductor diameter 20mm. CAT III 600V safety rating. Nominal current range: 20A, 200A. Continuous current range: 0.1A - 24A, 0.5A - 200A. Maximum non-destructive current: 240A. Lowest measurable current: 0.1A. Basic accuracy: 1.5 percent +0.5 A (48-65 Hz) (percent reading + floorspec). Useable frequency: 40 Hz - 10 kHz. Output levels: 100 mV/A, 10 mV/A. Maximum conductor size (busbar): 20 x 5mm. Output cable length: 2.0m.
MS
Reviewed in the United States on March 28, 2024
I have used this with my Fluke 179 but also with a much less expensive Kaiweets meter.
G
Reviewed in the United States on February 2, 2017
excellent precision.
M. Bendis
Reviewed in the United States on December 1, 2016
Works great with my existing meter. Nice to have a better resolution on lower voltages
Ernesto Bradacz
Reviewed in the United States on June 13, 2014
Needed to measure current in frequency motor drivers with fluke 87v, using low pass filter. Can be used in oscilloscope.
GSarmiento
Reviewed in the United States on November 19, 2014
Fluke I200S AC current clamp is a very handy instrument to measure power. I’m using this clamp with a Fluke 190 series Oscilloscope to evaluate power factor & watts. The BNC connector is perfect for oscilloscopes connections. The quality of included adapter for DVM’s (4mm banana) is good and very safe. The 20 Amps scale is reliable with loads below the 40% of the scale; if the load is > to 8 Amps is better to move the selector to the 200 Amps scale.
007 BOND
Reviewed in the United States on June 4, 2012
The clamp amp is what it is. It works well with the 289 or any other fluke meter. not too much to say because it worked.
Recommended Products
