Your cart is empty.
Your cart is empty. Front inner axle seal installer is suitable for All Ford Super Duty straight axle trucks 1978 - 2016 Dana 50 / Dana 60 Axle.
How to use:
Step1: Disassemble the front axle and remove the old inner axles seals
Step2:Install a new seal onto the seal driver.
Step3: Position the seal driver and seal assembly squarely into the housing.
Step4: Assemble 1/2 inch extensions as necessary to reach from the seal driver to the outer end of the axle housing.
Step5: Install the driving adapter onto the last 1/2 inch extension and drive the seal firmly into place by hammering firmly on the driving adapter.
Step6: Until the seal is seated all the way, then remove the seal driver and reassemble the axle
T mack
Reviewed in the United States on March 7, 2025
Not as the picture showed. Could not use a hammer to tap the seal in, but used a long threaded rod and basically pulled it in as shown on some YouTube videos. Using this method was very easy with no problems
Ernie Armijo
Reviewed in the United States on January 9, 2025
This tool is made of great quality and makes inner seals easy to install
Recommended Products
