Your cart is empty.
Your cart is empty.General Motors drivers value confidence in their vehicles, the premium parts that help keep them on the road, and the professionals that maintain and repair them. GM Genuine Parts and ACDelco are proud to work together as the only source for true General Motors Original Equipment and aftermarket parts. Our roots empower us. ACDelco has been at the forefront of automotive innovation since the birth of GM in 1908, but a strong start in automotive wasn’t enough. We’ve helped a woman fly around the world and a man traverse the surface of the moon. However, our history isn’t half as promising as our future as we continue to go forward with GM Genuine Parts by our side to offer and grow our technical training and rewards programs. From the assembly line to the finish line, GM technological innovation and improvement continues to build with GM Original Equipment as our foundation.
jonathan chatman
Reviewed in the United States on February 6, 2024
I have a 2001 Chevy express 2500 passenger van. This is a direct replacement for the window latch. As I was replacing this part the hooked extension that connected to the door hardware it snapped in the exact same place the original did. This is a very fragile part. Other than that it is a direct replacement and a decent price. Buy two just in case.
Greg H
Reviewed in the United States on March 30, 2022
Oe GM latch. Not Chinese garbage
Charles Benner
Reviewed in the United States on May 3, 2021
It works perfect
Chris
Reviewed in the United States on March 15, 2021
Clip snapped cheap
Dave M
Reviewed in the United States on November 30, 2021
Ok. this is not to review this latch but to offer a possible fix. The claw end of mine broke so it would no longer hold on to pin leaving the window flapping in the wind. Not wanting to spend the money I drilled a 7/64 hole near the claw. Put the claw end back on pin and wire tied with a small 3" long tie and snipped end off. Rotated tie around pin till I could close window. Done. If it breaks again, I have more wire ties. Good luck.
Michael Fullmer
Reviewed in the United States on June 24, 2020
Plastic is hard and has to be heated. I used a heat gun to heat it up. Be very careful because you can melt it. I used a pair of needle nose pliers to hold it with while heating it
Olemanmods
Reviewed in the United States on March 31, 2016
As I was pushing this onto the stud that it swivels around the clip broke. I kept it warm until I was going to install it so it wasn't because of the cold. I got a used one from a junk yard and didn't have an issue taking it off the original vehicle or installing it on my vehicle. I wasted my money on this purchase.
J.
Reviewed in the United States on March 21, 2016
Even though Amazon said this was the one, it wasn't. But, it appeared to be good quality. This is not the turn in style like the late model 99's, but a pin through type.
Recommended Products
$168.00
$ 79 .99 $79.99
$158.00
$ 63 .99 $63.99