Your cart is empty.
Your cart is empty.Product Description
M.2 SSD Heatsink with Built-in PWM Fan
GRAUGEAR has developed a state of the art heatsink using the combination of aluminum and copper metals in order to help dissipate the heat from M.2 NVMe PCIe SSD. The DTH(Direct-Touch Heat) copper pipes are used to absorb the heat from the drive spreading it up to the grooved aluminum surface of the heatsink. With this built-in powerful fan, it can dissipate more heat of the radiator.
Efficient Heat Dissipation
The G-M2HS03-F with its integrated heat pipe enables reliable cooling and by that especially low temperatures for the M.2 SSD, which allows it to run at full performance for an extended timespan. It fits both single and double sided M.2 2280 modules.
Notice: The height is about 1.34 inches(34mm). Please make sure that your PC case have enough space above the M.2 slot and it would not conflict with CPU heatsink or graphic card.
Direct-Touch Base Technology
Direct-touch base technology provides an optimized transfer of the heat to the pipes.
Dual 4mm Copper Heat Pipes
This product was built to perform with two 4mm heat pipes that are arranged to receive the maximum airflow.
Powerful Cooling Fan
Pulse width modulation (PWM) allows compatible 4-pin controllers to vary the speed of the fan intelligently. Low-noise operation due to high-quality rifle bearing.
Thermal Conductive Pads
In order to accelerate heat transfer by filling the gap between the SSD heat source and the heat sink, the heat energy of the SSD is effectively transferred to the heat sink fins, which also improves the life of the SSD and the product usage efficiency.
High-Density Aluminum Fins
Plate-fin design of aluminum alloy features an excellent temperature reduction performance. The better heat dissipation of SSD heatsink, the higher endurance of your M.2 SSD drives.
Easy Installation
Push-pins make installation easy and secure without screws. Available with 3-pin or PWM connectors to meet individual requirements
Hunter L.
Reviewed in the United States on March 28, 2025
My M.2. was 41C with my previous M.2 fan heatsink with 45% minimum at 40C to 75% fan curve and was very loud.With this my M.2. is at 37C with 35% minimum at 40C + 15% fan curves per 10 or 15C increase. It is also MUCH more quiet
Doru Nica
Reviewed in the United States on September 30, 2024
This is one more of the "German" companies made in China with products below German standard of quality and/or design. Just because you have a German address that does not mean it is a German product.The finish is good but what use is a nice finish and packing if the product design is flawed.The good:- very good finish and packing- large fan (relative)- 4 wires- 2 heat pipes- large mass to absorb the heat of short power burstsThe bad:- very expensive compared to competition- one sided install. You can only have the mounting screw on the heat pipes side. That might work with the airflow in your case or against it.- heatsink might be shorter than the M2 drive chips as the sink itself I shorter than its under tray (did not work well for Samsung 990 Pro).- very bad design of the under tray; interference with M2 mobo socket. Could not actually use or test against competition- It has large mass but too small surface for that mass to be able to quickly dissipate the stored heat.- The fan cable is a lot thicker and too rigid for the installed fan needs. Length is Okish, but if the fan header is far then there is no other choice than to have the cable cross the mobo instead of going nicely around for cable management (or use extensions).Overall, I don't think you should buy this heatsink. There are much better options and at a lower price point without sacrificing performance. If it fits your system, it is probably an Ok fan performance wise, but it lacks real engineering expected from a German product, and its weight to surface ration is not optimized.As other reviewer mentioned, my first order arrived w/o the fan. Second was Ok.Mine goes back anyway.
Gavan Brown
Reviewed in Canada on August 19, 2024
I have a PCIe 5.0 4TB Crucial T700 m.2 drive installed. It is the fastest nvme drive you can buy. Therefore, it generates A LOT of heat.It came with a preinstalled factory heatsink, which is VERY large. But even with that heatsink, the drives goes up to 90 degrees Celsius and completely shuts off when writing for a sustained period. For example when writing 100gb to the drive, it will shut off the drive it gets so hot.So I purchased this as a last ditch effort to try to keep it cool. This thing works very well. It has kept my drive below 50c regardless of how much writing I throw at it! It also idles at around 25c, which is insane.VERY MUCH RECOMMENDED!
シンク
Reviewed in Japan on June 5, 2024
m.2の熱が気になったで別タイプの物ですが、こちらもよく冷えます。負荷かけても50度いくこともなく、暑い時期になるので安定してくれていて良いもの買いました。
ThemAintKosherRules
Reviewed in the United States on February 25, 2024
My WD Black NVMe drive was running at around 58C before installing this. Within normal operating temperature, but heat is a killer so I decided to give this heatsink a try. Pleasantly surprised, the drive temp is now 48C under load and runs around 32C idle.Installation was a breeze even with Gigbyte's tool-less nvme drive "screw" replacement (I hate those things). Fan noise is non-existent, but I just might not be able to hear it as there are 8 120mm fans running and 3 2U systems in the rack this sits on. It's in my basement so it's not an issue.One thing to note is in my application it was not a tight squeeze but if the heatsink itself were any longer I would not have been able to use it as it would have hit the pcie release tab.If you are looking for a way to cool an nvme drive in your system this might be what you are looking for.
Daemoch
Reviewed in the United States on February 15, 2024
its not small, so watch your clearances; it was a VERY tight fit and they way it attaches is very tedious. Other than that, it isnt super loud or anything and looks pretty cool. I put it on an m.2 SSD that technically didnt require a heatsink but, like most people, I like to over do my cooling. Plus, this pushes some air across the backside of the videocard and out the top PCIe slot's vented plate and thats never a bad thing.
Chaz Jacob Lingenfelter
Reviewed in the United States on November 22, 2024
Great fit and plugs directly into motherboard fan plug. Can't say for sure if the fan works due to having 9 case fans but M.2 benchmarks very high and have had no issues with heat so my guess is good 👍🏻
C2G
Reviewed in Japan on November 12, 2024
SSDのヒートシンクについていたファンが煩く、換装するために購入。ほぼ期待通りの性能を有しており満足。ただまあ、これは自分の確認不足ではあるが、見ての通り筐体が大きく一番上のスロットに差し込む際にマザーボードのヒートシンクと干渉したりする。ファンのケーブルが横に出ているのも干渉した。（何とか付いたけど）
Alexander Reyes
Reviewed in the United States on October 12, 2024
good works fine, no issues
鉄治
Reviewed in Japan on September 21, 2023
B760M Pro RS/D4マザーのM.2空きスロットに装着 HIKSEMI LITE 2TB温度は5度～10度下がる感じで静音もいい感じ負荷時でも40度内を行ったり来たり GRAUGEAR商品は作りがしっかりした感じでセンスも悪くなくファンも安定してます 別売のG-M2HS06も試しましたが放熱性は上ですが夏場のケース内熱対流を考えるとFANがあった方が安定する気がしますB760M Pro RS/D4マザーのドライバーで示した位置ですので、かなりデカいのも付けられる感じもします
angelica ruiz
Reviewed in the United States on July 8, 2023
After installing the product I seen the drop in temp that is advertised but seeing it go back to previous temp numbers I checked and seen the fan does not spin no matter what I did to influence it. I removed and tested the fan on other fan headers but nothing worked changed the powers that the fan received but nothing I think I saw it spin for a second then nothing.
LucarioGUN Gaming
Reviewed in the United States on December 17, 2023
I had come across this cooler when I was comparing it and others with Sabrents passive NVME cooler and even though there was one reviewer here that said their fan did not work but the heat sink it’s self was still able to cool his drive by 10-15 degrees C I decided based on his review and others to purchase this and I am not disappointed. It was fun to install I highly recommend you peel the plastic off of the thermal pads with a fine tweezers as that was the easy way for me and apply the thermal pads like you would a band aid. The most tedious part of the installation was properly positioning the thermal pads but after you do it’s a breeze. I was able to create an optimized power curve for the WD Black 770 1 TB drive I installed it on in SIV which is the fan tuner that came with my gigabyte aurous elite motherboard and I got a 20 degree C drop in M.2 temperature on a 70 degree day. As I live outdoors i can get ambient temps of 15 degrees and this cooler can literally bring the temp of an M2 drive down to 44 degrees F which is what I set my thermal probe to read. For the practical design and the performance I got from this drive cooler it has earned five stars.
Chris
Reviewed in the United Arab Emirates on November 18, 2023
Fan doesn’t work and can’t install it due to design error
Recommended Products