Your cart is empty.
Your cart is empty.Stainless Steel Lid Handle for all Z--Grills 700 Series and also used for the Lower Cabinet Handles on the 700D.
Allen
Reviewed in the United States on May 16, 2023
Fits the grilla grill silverbac the curvature is slightly different. If replacing one one the storage door you might want to replace both.
Tenderfoot56
Reviewed in the United States on January 20, 2023
I purchased a ZGrills 7000 series Pellet Grill in November, 2022, and the design location of the wheels were placed at the light end of the grill and the handle to lift and move the grill was welded to the end of the Pellet Hopper which is very heavy. It's a thin round welded iron handle, and lifting it is pretty daunting when it's full of pellets or even empty. I decided to reverse the location of the wheels, placing them on the heavy end of the grill and install this beautiful new handle on the right end of the grill. It perfectly matches the ZGrills Original OEM Lid Handle in every way. I also added a 24" x 14" stainless steel fold out shelf to the grill since it didn't have one and I could not find one to purchase that would fit. Check out the pictures above.I'm very pleased with the quality of the handle and would recommend it highly. It's indistinguishable from the original OEM ZGrills Lid Handle.One thing to note is that it DOES NOT come with any bolts or washers, so you will need to purchase a couple of 1/4-20 x 1/2" long hex head bolts and washers to fasten this to your grill. I found them at Home Depot for a few bucks.I attached the handle just above the grease catch trough that is welded inside the grill which makes it very rigid. I also used a couple of 1" diameter washers on the inside to spread the weight around a little and minimize any flexing of the handle.Be warned that when you move the wheels and add the handle, it's much easier to lift and move the grill, but because of the majority of the weight is now being behind the wheels, you really should not lift the light end of the grill more than about 8" or so off the ground. The center of gravity for balance is only about 10 to 12 inches off the ground. If you lift the grill beyond that point, the wheels will want to come at you fast causing the hopper and pellet drive assembly to crash onto the ground possibly causing some damage to the grill. Keeping this in mind, navigating the grill is much easier now that I don't have to lift so much weight to move it around.
Recommended Products
$116.00
$ 52 .99 $52.99