Shopping Cart

Your cart is empty.

Your cart is empty.

Hantek Auto Ignition Probe - HT25 for Oscilloscope Automotive Acdessory Inductive Capacitance Sensor 2.5M Length 10000:1 Decay, Work with Oscilloscope 3 Ends

5.0 Write Review
Free shipping on orders over $29.99

$18.99

$ 8 .99 $8.99

In Stock
  • Inductive capacitance sensor (HT25 Automotive Ignition Probe) for use with automotive oscilloscopes.The HT25 lead wire is 2.5 metres long and has an attenuation of up to 10,000:1.
  • The lead wire has three ends, one for the oscilloscope as a BNC, one for the loot clip and one for the high voltage pickup clip to ground. The robbing clip over is an attenuator used to attenuate the robbing high voltage to low voltage, thus protecting the oscilloscope from charged shocks.
  • Used to test the spark ignition secondary overlap wave, overlap wave parameters, so as to achieve the detection and diagnosis of the engine ignition position, so that the ignition voltage of each cylinder over time directly from the oscilloscope display.
  • Attention: The test clip should not be directly clamped on the spark plug, but should be clamped on the insulated wire connected to the spark plug to prevent breakdown and electric shock.
  • NOTE: Keep at least 2 inches away from other high voltage power sources to avoid interference. Comes with 1 HT25 auto ignition probe.


Feature:
Auto Ignition Probe (HT25)
Auto ignition probe is a kind of inductive capacitance sensor, it must match with an oscilloscope. The loot line has three ends, a joint meet oscilloscope for BNC use, a clip for use, a clip grounding to pick high-voltage gleaned clip with.
Close to use, can be used to test a spark ignition secondary overlapping wave, overlapping wave parameters, thus achieved the detection, the diagnosis engine ignition position, make each cylinder ignition voltage changing with time directly from the oscilloscope display.
The loot line has three ends, a joint meet oscilloscope for BNC use, a clip for use, a clip grounding to pick high-voltage gleaned clip with. Loot clincher over is a attenuator, used for loot high-pressure attenuation for low pressure, thus protecting oscilloscope not electrify impact.
When used please note:
(1)">Test clips shall not directly clip in spark plug, should be caught in the connection of the spark plugs of insulation wire, in order to prevent the breakdown and causing a shock.
(2) To distance other high-voltage at least 2 inches apart, lest produce interference.
(3) HT25 leading line length 2.5 meters, the decay of up to 10,000:1.