Your cart is empty.
Your cart is empty.Product Description
Hipa 300486 Carburetor for Earthquake 43cc Engine Tiller Cultivator
fishpotpete
Reviewed in the United States on March 10, 2025
Worked perfectly on an EarthQuake 43cc auger. Started on the second pull after I replaced all the original fuel line parts and spark plug. No carb adjustments were required.Took about an hour or less to replace? I wasn't really paying attention. The only real issue was getting the fuel lines through the new rubber gas tank stopper. I put a drop of 3in1 oil in the holes and then the lines were easy to push/pull through.
Luke V.
Reviewed in Canada on February 18, 2025
Good stuff.Works
BFoz
Reviewed in the United States on February 17, 2025
decent quality
Ardy
Reviewed in the United States on January 8, 2025
Great Product, Works Perfect for our needs and easy to install.
Nathan
Reviewed in Canada on September 25, 2024
Worked perfectly on my Little earthquake two stroke tiller
Customer
Reviewed in the United States on August 9, 2024
Worked great. Installed and needed no adjustments.
Shawn
Reviewed in Canada on August 14, 2024
very good thanks in Canada
KSL
Reviewed in the United States on February 28, 2024
I had to tighten up the screws on the lower portion of the Carb for the priming bulb to draw fuel. Other than that installation was as easy as removing the old carb, and it fired right up. Used for Harbor Freight's 43cc Powermate Auger.
Jaime
Reviewed in the United States on December 2, 2024
It's like plug and play. After I replace the carburetor, I was able to start my tiller BUT and air filter did not fit.
Roberts Family
Reviewed in the United States on October 23, 2024
The gas lines from the tank on my Harbor Freight Auger were leaking, mainly the dry rot tank line grommet. It didn't hurt to have a new carb too. The price was good, and everything worked without needing adjustment.
G2
Reviewed in the United States on April 3, 2023
Borrowed my BIL's auger, first it would not start, so I pulled the filter and sprayed with ether, then it would idle but ran out of gas at speed. I probably could have just replaced the filter, fuel lines, and filter, but at this price it was worth it to just replace everything. Primes, starts, idles, and runs like new. As a plus, the new fuel tank grommet doesn't leak like the old one. The grommet is a bit of a pain, but I sprayed it with silicon and beveled the fuel lines, with a pair of pliers and a flat screwdriver, the whole job took 10 minutes or less.
Recommended Products