Your cart is empty.
Your cart is empty. Note:The color of the item may vary slightly due to photography and your own computer /Phone
Please allow some little manual measurement error.
Customer Satisfaction Guarantee
If you are not completely satisfied with our products, please do not hesitate to contact us to request a refund or exchange!
Note:Check your specific model's manual for compatibility,or Contact us.
Crash
Reviewed in the United States on February 20, 2025
Fits in the LaTrax Teton and runs great. Only problem is have is it’s not 100% water tight. Ended up spraying with plasti dip to create the water seal.
Sean Fitz
Reviewed in the United States on September 2, 2024
Shaft broke 2nd time out. But, I have to say, before it did , it was awesome! That’s why it’s 2 stars instead of 1. It made my Grom twice as fast before it broke. Maybe thicken up that shaft then you’ll really have something.
Mala calidad
Reviewed in Mexico on August 24, 2024
Si, el carro (latrax) corrió bien unos días, después notamos calentamiento y un día de la nada se quemó, no es buena marca
joh952
Reviewed in the United States on July 9, 2024
The media could not be loaded.
iRambes
Reviewed in the United States on July 26, 2024
The media could not be loaded.
Customer
Reviewed in the United States on June 21, 2024
Cant speak to longevity, but this thing rips! Super easy install and I didnt have to do any linking or programming of the controller. It was a plug and play job. I did splice a traxxas connector to it so it will accept a traxxas 2S Lipo battery. Installed in the 1/18 latrax because my son was burning through the traxxas brushed motors almost every time he took it out, without even driving it hard on a nicad battery. If your sick of changing brushed motors cause of over heat, I highly recommend this setup, and well worth the money! Will buy again!
Timothy RCDaily
Reviewed in the United States on December 31, 2024
Installation was pretty easy. I did have to switch the orange and yellow leads going to the motor to make it spin the correct direction, but this was pointed out in the manual.What they don't tell you is the extra power could harm the driveline components. I did my research, but still blew out three diffs. I should have shimmed the diffs and main drive shaft...oooops. My bad. There is a good instructional video on Youtube on doing this. After the shims were fitted, no more issues.I also bought a programming card for the speed control (Surpass Hobby Programming Card ), which I have yet to try out, as the factory settings were fine for typical use. It is nice to know I can customize some of the parameters.
Sasha Higgins
Reviewed in the United States on November 22, 2024
I got this for a WPL D14/D12, and it works great. It's a little punchy for a crawler build, which is why I think so many people experience snapped shafts. I got a Surpass Hobby ESC programmer card with my fingers crossed, and it paired right up and allowed me to modify the settings. Two of the motor wires needed to be reversed, but that's fairly common and not a difficult fix.
Eli
Reviewed in the United States on October 27, 2024
Replaced the stock brushed motor & esc from my latrax rally & wow.. it kicked into overdrive! Even though it's AWD, I'm forced to roll into it, but it'll still spin all 4 tires at speed. Great for carpet racing & bashing, but keep in mind the power it puts out.Best to upgrade other parts down the line as well.
Kyle
Reviewed in Canada on October 23, 2024
Ran it 3 times in a Latrax Teton before the shaft broke. Went a bit faster than the stock brushed motor that I've replaced twice before.
Recommended Products
$8.59
$ 3 .99 $3.99