Your cart is empty.
Your cart is empty.Product Description
QCC1 Propane Adapter Gas Regulator Valve Fitting
1/4" Male NPT
Converts Type 1 Connection x 1/4 Inch Male Pipe Thread to QCC1/Type1
100% Solid Brass
High quality solid brass construction makes it corrosion resistant
Easy to Install
Installation can be completed without tool twisting QCC1 end
- This nut replacement is great for any hose with a 1/4" female pipe end.
- Connect a 20lb-30lb propane tank to your regulator/hose assembly
- Up to 70,000 btu capacity.
Tomas Gonzalez
Reviewed in the United States on March 20, 2025
recomendado
Amy G.
Reviewed in the United States on March 14, 2025
Worked great
Milton david VIERA jiménez
Reviewed in the United States on March 10, 2025
Excelente muy bueno
james kinsey
Reviewed in the United States on February 20, 2025
works as intended
Grant 16 Racin
Reviewed in the United States on February 18, 2025
All good
macko
Reviewed in Canada on February 14, 2025
works well
Alex B.
Reviewed in Canada on September 24, 2024
Works much better than POL adapter I was using before.
Bandit
Reviewed in the United States on October 28, 2024
Work very well and let you add what you want
feelthepayne
Reviewed in the United States on September 14, 2023
This says it is for standard 20lb BBQ propane tanks, but I had a hard time getting it to thread on correctly, to the point where I was almost sure it wasn't the right threads. After a few more tries, I was able to get it to thread on, but it still felt like the threads were very tight. I was barely able to get it tight enough to depress the safety valve. Seems to seal ok. Haven't noticed any leaks.
Scott Archel
Reviewed in the United States on August 6, 2023
This propane adapter gives you the most options if you want to reconfigure in the future. Most hoses with the QCC1 adapter have regulators which are crimped. The old pol adapters have fittings that go to flare, but if you want something with the new QCC1 fitting, going to 1/4 NPT is your best option. This allows you to make your own configuration and makes it easily serviceable.The problem is that the hex bolt is on the inside of the knob, which makes it nearly impossible to prevent one side from swiveling as you tighten on the NPT side. Most people (including myself) will try to secure to tank then tighten hose or regulator to the NPT side of the adapter. This leads to leaking.The right way to do this is to use a 18mm deep hex socket and secure 1/4 NPT fitting to the adapter before you connect the tank. It can be either impact or non-impact rated socket. Both have enough clearance inside the knob to catch the hex bolt and not touch the mating side of the adapter. This will allow you to easily tighten your 1/4 NPT fitting.
Recommended Products