Your cart is empty.
Your cart is empty. Optional Aluminum Servo Mounts for the Grom series.
FEATURES:
Two position mount for stock servo and Savox Servo (SH-0265MG)
CNC Aluminum construction, black in color
Direct fit hop-up requires no modifications needed
YOU WILL RECEIVE:
One servo mount with ESC and Reciver mount
REQUIREMENTS:
Installation following the model manual
SPECIFICATIONS:
length:
COMMENTS:
- Replaces Arrma factory plastic Servo Mounts Block SPMXSE2625RX or ARA320753
Raul
Reviewed in the United States on February 1, 2025
Amazing. I like that these are longer than the carbon fiber ones in the furi tek kit and the arrma ones. Gave me enough room to mount the spectrum receiver I stole from my 3s big rock
Chad Richardson
Reviewed in the United States on January 18, 2025
I put this in my Mojave grom, the Arrma one was backordered when i was trying to upgrade the Mojave, so I got this one. I have broken 2 servos where they mount due to this design, I don't understand how. But the servos in my Granite and Typhon Grom are both still fine using the Arrma mount. I tried this on my Mojave and have had nothing but problems.The first servo I assumed was damaged from an impact, but while still installing the replacement servo I noticed the housing had cracked around the mount before I even got it fully installed in the RC, just screwing it to the aluminum mounts was somehow able to crack it. After seeing the replacement servo broken very similarly to the way the first one was I'm not longer convinced my minor wrecks are what broke my first servo.I have ordered a THIRD servo and an Arrma servo mount. I will no longer use this as it has cost me way too much in broken parts.
Rebecca Barth
Reviewed in the United States on September 4, 2024
A lot of people have complained there's no instructions. There's literally 3 parts. 3 possible ways to put it together and only 1 where the screw go straight in the servo. It's pretty easy to figure out. I would give the exact way it goes together here, but frankly it's buried and I don't remember. Lol. I do however remember that I put it together wrong and it wouldn't line up the top plate was crooked and straightening it made it so the servo wouldn't line up anymore. I simple turned the legs over and it all went together perfectly. I'd say a very well designed part. Much better for than the factory Arrma. And since it's metal it helps to offset the weight of the heavier 3s pack in my brushless upgrade. Fast shipping perfect fit. Better than Armmas. Can't go wrong with this one.
Gayleen McGarry
Reviewed in the United States on July 29, 2024
The included screws don't even fit in the included hardware whatsoever. No instructions included either, which is stupid. Says to check the vehicle's manual for instructions but there is nothing even remotely close. Absolutely horrible product. I was expecting better from a name as popular as Hot Racing. Not buying from HR again
Bryan
Reviewed in the United States on November 8, 2024
Nice product, but there are multiple ways it can be installed and the included hardware did not fit my servo.
Rob G.
Reviewed in the United States on October 8, 2024
I had high hopes for this product, but struggled and finally gave up trying to use the tiny flimsy awkwardly designed chassis mount brackets. They might work better if they were made out of aluminum, etc. The whole thing was not sufficiently stable to hold the steering servo properly. They need to reset it somehow.
Recommended Products
