Shopping Cart

Your cart is empty.

Your cart is empty.

Hot Rod Rubber Shifter Boot with Chrome Plate 5 5/8' X 6 3/4' Universal

5.0 (8) Write Review
Free shipping on orders over $29.99

$15.95

$ 7 .99 $7.99

In Stock
  • 5 5/8" x 6 3/4" At The Base
  • Designed to fit GM350, fitment for Automatic or Manual Shifters Hurst, B&M, ETC
  • Comes with chrome trim plate and hardware for installation.
  • High Quality Shifter Boots
  • Sold Each


Rubber Shifter Boot With Chrome Plate 5 5/8" x 6 3/4" Manual Automatic 350.
High quality black rubber shift boot comes with 4 screws and chrome trim plate for easy installation.
Fits Hurst, B&M, Automatic or Manual
Base Measurements: 5 5/8" x 6 3/4"
Looks Great!
Sold Each.


Joe
Reviewed in the United States on March 23, 2024
Just as described and fits perfectly in my rat rod. At first I had the rubber under the chrome plate but I then realized the rubber would fit better from the bottom. So I sandwiched my console with the chrome piece and the rubber piece.
Customer
Reviewed in the United States on December 28, 2023
garage
Darren
Reviewed in the United States on December 23, 2023
I used this to replace the ripped and worn out shifter boot on a Chevy Kodiak C70 truck. even though the shifter stick hole is square it sealed around the round shifter stick in the Chevy. It was a good replacement for my truck.
Shirley
Reviewed in the United States on January 29, 2020
Item was exactly as stated. Good fit and great price.
Capt.
Reviewed in the United States on December 6, 2018
Chrome trim piece flimsy. Careful not to over tighten base plate which there are no stainless screws with it so you'll need to go out and buy hardware.
Mike P
Reviewed in the United States on June 3, 2017
As you can see in the pic it's not a perfect match of rubber and the very thin (sharp) chrome metal.I bought it for a Lokar application and I'm not sure it will fit - it seems to be not tall enough and my center hump is too curved (or a combo of both really). Anyways - the Lokar one is closer to $100 so I figured I could sew (or have the wife sew) a vinyl sleeve for it it's worth $10. The thin metal, as other reviewers state, does make it more malleable and easy to contour to any application. For $10 give it a shot :D
Rocky S.
Reviewed in the United States on June 22, 2017
It's about what I expected. The chrome trim is very thin and will bend and warp if you suck the screws down too tight but then again it was less than $10. For the money, it does the job just fine.
Rory H.
Reviewed in the United States on May 17, 2016
Good quality. Flexible rubber. Chrome plate is thin.