Shopping Cart

Your cart is empty.

Your cart is empty.

HSS 5/16'-36 UNS Machine Tap, 5/16 x 36 UNS Right Hand Thread Tap

5.0 (4) Write Review
Free shipping on orders over $29.99

$8.99

$ 4 .99 $4.99

In Stock
  • 【Size】Length: 2.60"/66mm, Thread Head: 0.67"/17mm, Square Head: 5.0mm x 5.0mm (L*W), Shank Diameter:6.3mm, Pitch: 36 TPI.
  • 【Feature】Standard thread design, made of High-speed steel with high hardness and toughness, provide rapid chip removal for efficient threading.
  • 【Application】Make or repair thread, suitable for most metals, copper, alloy steel, cast iron, aluminum, brass, abrasive steel, A3 steel, iron plate ETC.
  • 【Usage】Can be used with manual equipment or special processing consoles for tapping, Appropriate addition of coolant can extend the service life when tapping.
  • 【Package Included】1pc 5/16-36 UNS Right Hand Thread Tap.


Product Description

Thraed Tap

Straight flute design, used for through-hole and shallow blind hole tapping.

Brand Aceteel
Model Straight Flute
Cutting Direction Right Hand
Material High-Speed Steel 6542

Tips:

  1. Before tapping confirm whether the diameter of the round hole is appropriate, and take protective measures when working.
  2. When tapping, it is necessary to add water or coolant to cool down to prevent excessive temperature and reduce tap loss. If it encounters difficulty in rotation, the tapping should be suspended.
  3. Be sure to select the appropriate cutting oil for the complex tapping process and apply anti-rust oil for maintenance after use.
Aceteel

Per Spett
Reviewed in Sweden on January 26, 2025
Fungerade perfekt
Chad
Reviewed in the United States on September 16, 2024
Works well. Granted it is only used to cut brass at this point. Should hold up a long time for my use.
Scott Heaslip
Reviewed in Canada on August 6, 2022
Recommend
HockeyGuy
Reviewed in Canada on October 1, 2022
It did the job. I used it to tap 2 brass shell casings. The end of the tap is wore out already. Its hard to get it started into the new threads now. But with a little jiggling at the start I can still run the bit in and out. If you need a tap for long-term then I recommend buying a better quality.