Shopping Cart

Your cart is empty.

Your cart is empty.

HTTMT MT325-018- Load Resistors LED Turn Signal Controllers Compatible with Fix fast flash Turn signal

5.0 Write Review
Free shipping on orders over $29.99

$8.99

$ 4 .99 $4.99

In Stock

About this item

  • This 8 Ohm, 25 Watt resistance can be connected across the turn signal bulbs to simulate the load of a regular filament bulb.
  • This will solve LED related turn signal problems such as hyper flashing, no flashing or burnt out bulb indications.
  • One resistance is required for each turn signal bulb.
  • Resistance for LED light, 25W 8ohm resistance, wired resistor , 2 X resistance Can be used with LED turn light of cars, bikes


Features:

  • Beautiful golden aluminium housing

  • 25 watt ,Pre-wired

  • Dimensions: Approx. 2.65(L) X 2.7(W) X 1.4(H)cm (1.04 X 1.06 X 0.55 inch)

  • Correct too-fast flashing

  • Stop bulbs blowing


Fitment:

This light is universal fit and it is not specific design for any motorcycle
  • All Years & Models

  • All Years & Models

  • Kawasaki All Years & Models

  • Suzuki All Years & Models

  • Ducati All Years & Models

  • KTM All Years & Models

  • All Years & Models


NOTE:
  • Resistance for LED light, 25W 8ohm resistance, wired resistor,

  • 2 X resistance Can be used with LED turn light of cars, bikes

  • Simply connect the load resistor to the 2 wires (signal and ground) leading to the signal.

  • Polarity is not important.

  • If your signal has 3 wires, then omit the running light wire as this is unaffected when the turn signal is activated.

  • Resistor will get HOT when signal is activated.

  • Do not mount directly to plastic surfaces.