K. Nimmo
Reviewed in the United States on February 26, 2025
Do not buy. I wired it in without looking closely at the fan because my I need to get the incubator set asap. After sparks started to fly, I noticed that the fan was a dc instead of ac. Someone could be serious injured by this product.
Erik F.
Reviewed in the United States on April 30, 2024
Converted still air incubator in no time. Worked perfectly.
Customer
Reviewed in the United States on September 30, 2023
I like the product only thing is the glue was dried out and I was not able to use it. Overall product is good.
Elias Garcia
Reviewed in the United States on July 3, 2023
The fan kit arrived well packed, undamaged and faster than estimated. The enclosed instructions were concise and easy to follow with accurate photos. The fan worked as it should, but you will have to cjange your thermostat/controller settings to get the desired temperature again for your incubator. HOWEVER, get some fast drying superglue from your favorite local store or whatever as backup for the superglue that comes in your kit.Right off the bat, BAD SUPERGLUE ISN'T THIS SELLER'S FAULT. Sometimes the glue just doesn't work like it should so test it first. Test the superglue from the kit for to make sure it'll dry. If it does, use it. If it doesn't, test your backup superglue. If it dries use it. If not, get another superglue from a different store and test/use that. When heat and moisture is applied to wet or not fully cured superglue, it causes cyanoacrylate fumes. The last thing you want is to turn your incubator into a CSI superglue fume hood for fingerprints that'll fumigate & clog up your eggs' pores and frost all the interior of the incubator with cyanoacrylate and maybe weaken or kill the embryos. The superglue supplied in my fan kit hadn't dried after 30 minutes when I tested it. It didn't completely dry after I sanded the test strip with baking soda either. The superglue was not the seller's fault at all. Sometimes the glue is just bad for whatever reason and you won't know if you don't test it beforehand. If this wasn't a 1 chance to do it right, live, sensitive animal application I wouldn't have even mentioned it.The fan kit is a great upgrade that should increase your hatch rate. I'm very satisfied with my purchase.
Richard Owens
Reviewed in the United States on February 5, 2023
Easy install except the glue was junk and probably unnecessary to use. Just donโt Neanderthal the heater and youโll be fine putting it back together. Iโm happy with it.
Melissa Vicknair
Reviewed in the United States on February 19, 2023
Got this to add circulation to my still air little giant incubator. It came in super quick. Followed the super easy directions and it made the control panel spaz out. Called customer service and got a replacement in 3 days. New one works flawlessly! Here is to upping my already good hatch rate!
wilma whateley
Reviewed in the United States on July 7, 2022
I was Leary when I bought the fan that I could install it in my incubator, but the instructions were simple to follow and in just a few minutes I had a fan in my incubator and had the best hatching ever of my baby chicks.
Lilli
Reviewed in the United States on December 11, 2020
Buy this one! This is the one that works and fits, and does what it is supposed to do with no issues! I bought a knock off and it failed miserably, and with deadly results.Because I bought the still air version - partly due to the low cost and my need at the time - I did bought an egg turner, but the heat and humidity was so uneven that I had a very high mortality, including chicks stuck in their membranes.Buy THIS unit - it is also quiet, and the perfect aftermarket product to turn your Little Giant into the incubator that I should have bought in the first place.