Your cart is empty.
Your cart is empty. These are angled as to not bend the pinch weld as the car is lifted by a floor jack.so that the vehicle can be jacked up safely
without damage to the weld or Rocker Panel
Made of billet aluminum and be made to be left on the car while driving.Sold as a set of 4
Fit for jack pads for the 6th gen Camaro, except convertible
Machined from Billet Aluminum and anodized,Many colors available:Red,Black,Blue,silver
Floor jack pads are designed to be sturdy enough to support your car while soft enough to resist pressure for your floor jack
Michael Franco
Reviewed in the United States on March 12, 2025
Excellent, went on well.
Deb and Bill from Perrysburg
Reviewed in the United States on September 10, 2024
These lift pads save the pinch welds from poor lifting practices, and gives you a target for your floor jack. I had two lift pads go missing on my 2023 Camaro 1LE that I had purchased from ZL1 Addons. I transfered them from my 2016 and apparently did not tight those ones enough. The new ones seem to be identical to the orginals, minus the logo. These worked just like the one from ZL1 Addons.Bill
Rob
Reviewed in the United States on August 11, 2024
Works like any other brand for much less. I took the advice from the other listings and used the longer bolts and had a much easier install. Overall they work, good price, and makes jacking up the car much faster.
Jon
Reviewed in the United States on May 30, 2024
I was able to install these without lifting up the car. Wasn't too bad. Once you figure out the first one, the rest are easy. I did get the M6-1.0 x 25mm screws from Home Depot as recommended by another reviewer, and I used blue threadlocker. Put the screws mostly in before you install it on the car. Makes it easier.
Brian
Reviewed in the United States on November 23, 2024
These pads work GREAT! They install easily and do not interfere with anything and fit perfectly on your cars seam weld!I couldn't be happier!
kiayande levi
Reviewed in the United States on October 4, 2024
I bought these before. Helps prevent the bending on the underbody of the car. Securing them can take some effort.
Josh V
Reviewed in the United States on March 9, 2023
I installed this on my 6th gen ZL1 and they fit perfectly. There aren't any instructions but there are plenty of youtube videos out there for them. I didn't have any issues with the set screws being too short. I did put blue thread locker on them and snugged them down. Don't overtighten them or you could strip them. It is steel screws going through aluminum. I lifted my car with no issues or damage to the underside.
Les Bales
Reviewed in the United States on December 20, 2023
This is a great product, but you must replace the existing set screws with set screws that are 1 inch or longer. The ones that came with the product are entirely too short. It is the reason that most people strip out the threads. Trust me on this one. M6x25 is the correct size screw.
Recommended Products
