Shopping Cart

Your cart is empty.

Your cart is empty.

JHEMCU F411 ELRS AIO Flight Controller ICM42688-P BLHELI_S 1-2S 12A 4in1 ESC ELRS 2.4G 25.5X25.5mm for FPV Micro Drone DIY Part (F411 ELRS AIO 1PC)

5.0 (1) Write Review
Free shipping on orders over $29.99

$43.08

$ 21 .99 $21.99

In Stock
  • using STM32F411 processor, ICM42688-P gyroscope, integrated OSD, built-in 5V/1.5A BEC lifting voltage circuit, built-in 9V/2A BEC boost circuit provides a stable 9V output for Tu Chuan sockets, use HD in 2S at 2S The sky will not be black on the end of the sky.
  • The built-in independent ELRS 2.4G receiver supports 1-2S 12A brushless electrical roads. The circuit board has no black box and gas pressure meter module. If you choose a 1S power supply difficulty, please add the startup power value to the value that can be initiated appropriately.
  • If you do not use built -in ELRS, you can also support an external SBUS receiver. You need to shorter the SBUS short -connected pad to block the ELRS receiver function integrated on AIO.


Technical Parameters:

  • Model: JHEMCU F411ELRS
  • Main -control chip: STM32F411CEU6 (100MHz, 512K)
  • Gyroscope: ICM-42688-P
  • Blood pressure meter: None
  • OSD chip: AT7456E
  • Black box: none
  • LED programming: support
  • BB ring: support
  • Input voltage: 1-2s
  • I2C interface: support
  • BEC: 5V/1.5A
  • BEC: 9V/2A
  • Camera input: Support
  • Serial control port: two roads (UART1 is used for internal ELRS receiver and external SBUS, UART2 is used for diagram)
  • Flying control firmware: Betaflight 4.4.3 JHEF411.HEX
  • Electric current: 12A * 4
  • Current meter: Yes
  • Firmware: BLHELI_S Z-H-30.HEX
  • Whether to support blue bird: support 24K 48K 96K
  • Flying control default electrical driver protocol: DSHOT300
  • Type of receiving machine: ELRS
  • Receiving frequency: 2.4G
  • Receiving machine signal protocol: CRSF
  • Receiving machine firmware: jhemcu EP24. V3.2.0
  • Whether to support wifi update ELRS firmware: support
  • Whether it is an independent receiver: Yes, a non -SPI method
  • Conversion of holes and shocking balls: M3, 25.5*25.5mm
  • Maximum shape size: 30*30mm
  • Weight: 4.9G
Reminder:
Due to the high integration of the PCB, the overall solder joints are relatively small. For novices who have no welding ability or freshman who are not used or just started, or friends who know nothing about Betaflight, please start with caution. We will not provide handlebage technical support.

George A Webb
Reviewed in the United States on March 9, 2025
Packaging was in bad shape, invisible. Cost was poor for the quality of the product, which was also invisible. Whole order didn’t arrive. Already had a review denied for trying to share being charged for no product. Will continue to post.