Your cart is empty.
Your cart is empty.Universal 2 wheel pocket door "V" track hanger, replaces any 7/8 inch diameter 1 wheel or 2 wheel top mount pocket door hanger, yellow zinc metallic finish, lifetime warranty.
Dann Marchese
Reviewed in the United States on February 8, 2025
It was easy to install, fit in track great.
J Weber
Reviewed in the United States on August 8, 2024
I’ve had a couple replacement sets in a short amount of time on my pocket door and these are the best ones. If I need more, I would buy these again. Didn’t move once the height was set and rolls nice and smooth.
Brittney
Reviewed in the United States on December 4, 2024
This was a replacement for an old wheel that seized. Works great, very simple easy installation. It took more time to get access to the door then to do the replacement. Worth every penny.
Felipe
Reviewed in the United States on April 17, 2024
Excellent replacement for solid core pocket door rollers. Much better than the ones it had previously. I'm confident these will take the frequent use and abuse much better. I like them a lot and now I have two adjustment wrenches when I used to have none.
Customer
Reviewed in the United States on May 13, 2023
Very nice and sturdy. An upgrade from the standard pocket door rollers. Good for a solid wood door. You will need to notch out the top of the casing to clear the adjusters though. But that was easy with a Dremel with a flat saw blade. I would recommend these to anyone looking for an upgrade to the standard pocket door rollers.
Chris in Houston
Reviewed in the United States on June 3, 2021
Tried before to fix a pocket door with other replacement hardware that didn't work well at all. It kept jumping the track, and the overly complicated height adjustment kept moving.This is good, heavy duty hardware that holds a solid wood door (maybe 50 lbs.?) and rolls smoothly and firmly in a 60 year old steel track.However, there are 2 things to know heading into this:1. As others have noted in reviews, the height adjustment screw and block sticks out and required modification to the door frame to get it installed. But it only required that modification (a couple of half inch long notches) to get the door (with hardware installed) into the track. Once it was in the track, everything cleared fine.2. The packaging showed that the edge of the plate line up with the edge of the door. After measuring the gap between the center of the track (where wheels will roll) and the door frame, it was obvious that I needed to mount the hardware so the wheels fall along the centerline of the door. So do some measuring and get it right the first time.
Builder Boy
Reviewed in the United States on July 27, 2020
This is a sturdy and well-built piece of hardware. But it's not good for many retro-fit applications.If your track is centered on the head jamb, then your rollers must also be centered on the door itself. But when the rollers are centered on the door, the adjustment nut hangs over the door about 3/16" and hits the frame.....thereby making it non-usable.If however you are installing a pocket door from scratch, this will work great. Just make sure and offset your track, to accommodate the adjustment nut.
North Californian
Reviewed in the United States on December 9, 2018
This is a good heavy duty hanger that after door frame mods works for me. My channel is in the middle of the door pocket (the hanger wheels are centered on the door). When test sliding the new hanger in the channel, the adjustment bolt head, threaded receiver, and nylon block all hit the pocket door frame. I used a hack saw blade (hand held) to make a cut in the door frame just below and above the interference, then used a chisel to remove the interfering portion of the door frame. I also filed down the threaded adjustment receiver since I have a metal band in the door frame that I did not want to cut. Not that big a deal. They work fine now.
Recommended Products
