Shopping Cart

Your cart is empty.

Your cart is empty.

kimllier 4Pcs AXA 250-101 Quick Change Turning and Facing Lathe Tool Post Holder Fit for 250-111 or 250-100 Tool Post 12 Inch Swing Dia

4.5 (1) Write Review
Free shipping on orders over $29.99

$35.54

$ 16 .99 $16.99

In Stock
  • steel
  • The lathe tool post holder is made of steel hardened accuracy grinding, with strong rigidity and high hardness.
  • All parts are hardened and grounded to make the AXA 250-101 lathe tool post holder completely sealed.
  • All parts of the quick change lathe tool post holder are hardened and accuracy lapped. Accuracy design ensures the repeatability accuracy of the tool post.
  • Our tool post holder is easy to install, built in quick replacement tool versatility, can be quickly replaced tool rest. Turning and face tools can be fixed together to save more operation time.
  • V-groove design is more efficient, securely holding 3/16-1/2 inch square diameter tool bits, suitable for AXA tool post 250-100 or 250-111, up to 12 inch swing.


4Pcs AXA 250-101 Quick Change Turning and Facing Lathe Tool Post Holder


Specification:

Material: steel

Tool Bit Range: 3/16-1/2 inch

Features:

1. All parts are hardened and grounded to make the AXA 250-101 lathe tool post holder completely sealed.

2. All parts of the quick change lathe tool post holder are hardened and accuracy lapped. Accuracy design ensures the repeatability accuracy of the tool post.

3. Our tool post holder is easy to install, built in quick replacement tool versatility, can be quickly replaced tool rest. Turning and face tools can be fixed together to save more operation time.

4. V-groove design is more efficient，securely holding 3/16-1/2 inch square diameter tool bits, suitable for AXA tool post 250-100 or 250-111, up to 12 inch swing.

Package Includes:

1 x 4Pcs tool post holder AXA 250-101


Jon P
Reviewed in the United States on October 20, 2024
They were lightly oiled, wrapped, and individually boxed. The tool holders were finished well with concise cuts. I did not have any problems with the screws but I have replacements just in case anything happens with them. The two adjusting nuts were fine. Only one had a very slight wobble and nothing that would really affect your work. If you really needed to you could make thicker depth stop nuts. I am not in a hurry to do that.These fit my AXA wedge-type tool post without any issues. The post was able to clamp down on them without adjustment.