Shopping Cart

Your cart is empty.

Your cart is empty.

LS Oil Pump Pickup Tube Girdle Pipe Hold Down Brace Support Billet Bracket MADE IN THE USA Compatible with GM Chevy LS Series Engines LSX LS1 LS3 LS2 LQ4 LS6 LQ9 5.3L 6.0L 6.2L

Free shipping on orders over $29.99

$14.99

$ 7 .99 $7.99

In Stock

About this item

  • Compatible with all LS Series Engines 1997-2014 (GEN. III/IV small block chevy)
  • The factory oil pickup tube on LS engines is only secured by one bolt. This can potentially lead to a poor seal on the oil pump. Our Billet aluminum Oil pump girdle solves the issue by placing a clamp on both sides of the tube, securely holding it in place.
  • DOES NOT fit any LS oil pickup tube with welded flanges (GM # 12608593, Holley 302-1 and similar tubes). DOES NOT fit pickup tubes with two screw holes on their flange (Holley 302-2 tube and similar tubes).
  • Proudly made in the USA from Aerospace Grade Billet Aluminum
  • We are an AS9100D and ISO 9001:2015 Certified Manufacturer. Parts we produce fly at 30,000 feet where failure is not an option.


LS Oil Pump Pickup Tube Girdle Designed to secure the oil pickup tube to the oil pump with 2 bolts instead of the factory 1 bolt to provide ultimate clamping and sealing. Eliminate sag and give you extra insurance on your engine build. Not designed to be used with factory oil pickup tubes with welded on retainer tab. (You can carefully grind the tab off so this will work) Comes with 2 metric grade 10.9 bolts and billet aluminum girdle. Proudly made in the USA from aircraft grade billet aluminum.


Douglas
Reviewed in the United States on February 24, 2025
Just what i needed
Value4ME
Reviewed in the United States on February 24, 2025
Fit perfect. No issues.
Mike & Roberta
Reviewed in the United States on February 20, 2025
Great Upgrade for LS1
Stephen
Reviewed in the United States on September 16, 2024
I semi-stripped the factory mounting location on my oil pump so I grabbed one of these to use the ensure a secure fit.This is much easier to install with the timing cover off or loosened and pushed towards the crank.Feels top notch and think it will stand the test of time.
Sh
Reviewed in the United States on August 18, 2024
Bolted right up. I'm sure it will do the job.
tjjeepin
Reviewed in the United States on December 27, 2024
Worked as advertised. Clamps the pickup tube to the oil pump very well.
eric stufflebeam
Reviewed in the United States on December 15, 2024
GM should of installed this from factory. It's even tapped in the block for one. Definitely helps oil pressure and keeping your oil pump seal from blowing out especially under boost and high pressure. Very easy to install if the motor is out of the vehicle.
Tim
Reviewed in the United States on October 21, 2024
The concept is great, I was gonna add this to my pickup while replacing the o ring, but impossible without removing the timing cover as well(Even if you get it started, you can’t get a tool on it to tighten it), but I’ll hold it maybe one day I’ll use it on my one of my builds…
Chris
Reviewed in Canada on October 20, 2023
Fit 2007 Chevrolet avalanche 5.3L, works great
Recommended Products

$39.00

$ 19 .99 $19.99

4.7
Select Option

$21.79

$ 10 .99 $10.99

4.9
Select Option