Your cart is empty.
Your cart is empty.The Hilljak Quickie Loader is designed to specifically fit Smith & Wesson M&P 9 Shield (1.0, 2.0) 40 Shield, Springfield Armory XD-S XD-E 9mm single-stack magazines. Also fits Honor Guard and Smith & Wesson 908, 3913, 3914, 3953. The Quickie Loader features an ergonomic form factor and provides superior comfort, speed and design! Material: 3D printed polymer plastic Get Loaded Quicker! Note: THIS DOES NOT FIT S&W M&P SHIELD PLUS OR 9 SHIELD EZ
dennis juliot
Reviewed in the United States on March 12, 2025
Works great
Tracy Laudenslager
Reviewed in the United States on February 5, 2025
Fast service, Great item. Exactly as ordered
Christopher D Atwood
Reviewed in the United States on February 15, 2025
does not fit M&P 9 Shield magazines — not at 10 or 13 capacities. I had trouble getting it over the top of the magazine and then couldn’t get it to go low enough to depress the ammo so I could load the next round.If I am a moron, I’ll happily change this. I did my best to follow the directions.
Mike O'Keefe
Reviewed in the United States on May 3, 2024
I was having difficulty getting the last few rounds loaded into my magazines. This works very well. Takes just a little wiggle to get each round in, and I can get the full 8 rounds loaded quickly.
Crissie Williamson
Reviewed in the United States on March 17, 2024
New guns are stiff and hard to load....I highly recommend! So much easier and way faster
P. Rains
Reviewed in the United States on December 2, 2023
Using this to load M&P 40 2.0 Shield mags. It works but it's pretty clunky and takes a lot of effort and coordination due to the tolerances being way too tight. Not for fast loading for sure. So it's just.....meh.
Stumpkiller
Reviewed in the United States on October 7, 2023
I have MagGuts +2 springs and followers (and a few Taran 10 round magazines for the Shield. This gets them filled up easily. I recommend loading the first one without the unit and then you can set the mag base on a table and thumb-push the loader, or, put your thumb under the baseplate and hold the unit between fingers like a syringe and load without a table. 3-D printed, but that gives it just the right texture for grip. Good job!
Trin Sumlar
Reviewed in the United States on January 29, 2023
The flange to grab is solid, but it could maybe be a bit more flared or grippy. This is for the single stack, which is clearly stated in the listing, and I have a double stack so I wasn't able to use it. Feels and looks sturdy and like it will last well though
Recommended Products
$44.95
$ 21 .99 $21.99
$13.95
$ 6 .99 $6.99
$12.98
$ 6 .99 $6.99