Your cart is empty.
Your cart is empty.From the Manufacturer
12" X 100T Miter Saw Blade Micro Polish
Tropical Robb
Reviewed in the United States on June 17, 2024
I use this blade for large cuts on acrylic and MDF. I've cut panels of Baltic Birch plywood also. Of the many blades I've tried over the years, the Makita and Diablo blades yield the best results, the cleanest cuts. The Makita blade is slightly better on the Baltic Birch with less splintering. With a wrap of painters tape, splintering is just about eliminated.
Mike
Reviewed in the United States on March 22, 2024
It seems to be an excellent blade, miters clean in soft and hardwood and doesn’t chip veneer. Time will tell. I’d buy it again for that price
Bill T Millwood
Reviewed in the United States on March 2, 2024
I am a finish carpenter and I have used very expensive blades and very cheap blades and the Makita blades perform as good as any expensive blade out there for a great price. Try them you will see.
Buckeyeborn
Reviewed in the United States on April 4, 2024
Thin kerf, extremely smooth cut surface and much quieter than others. I have four 10” and two 10” for table and miter saw.
powerfulkev
Reviewed in the United States on April 19, 2024
I used both a 10" and 12" version of this blade during a home project replacing all my casing and baseboards. They make excellent cuts for finish work considering they are reasonably priced.
Caleb
Reviewed in the United States on March 9, 2021
I've had a red blade on my miter saw for a long time now and it seemed to do just fine, but I could tell i was getting a bit more tearout than normal so I gave this blade a chance. Now either my old blade was a heck of a lot more dull than I realized or this blade is SHARP (probably both) - this makes precise and clean cuts, all with a thin kerf for minimal waste. I've cut through about any kind of hardwood you can imagine and no burns or dumb paint wearing off either!
Gilbert Bédard
Reviewed in Canada on October 30, 2020
I am working on hardwood stairs , the cut is perfect. please with this purchase
Ben
Reviewed in the United States on December 19, 2019
As you would expect from buying a blade with so many teeth, it makes extremely clean cuts through all types of wood I've used (walnut, oak, mahogany, poplar and obviously pine). I'd say it cuts across grain with a smoothness somewhere between 120 and 220 grit sandpaper. Been using it almost daily for both fine woodwork as well as construction (too lazy to switch out blades) and it's held up just fine after three months, with no noticeable decrease in cutting quality or efficiency. A good product for a great value. I can't compare it to more expensive blades as I've never used them, but I can't imagine it gets better than this.
DM
Reviewed in the United States on April 3, 2018
Really nice. Smooth cuts. Didn't last as long as I thought it should have.
Chris
Reviewed in Canada on April 2, 2018
Great blade, mirror like cut finish.
Hiroaki Masuda
Reviewed in Canada on August 13, 2017
Great item!
José
Reviewed in Mexico on July 19, 2017
Muy buen disco cortes muy limpios, un poco pesado pero con la maquina que lo tengo no importa lo recomiendo
ALUMAX
Reviewed in Mexico on January 14, 2017
no le doy 5 estrellas por que aun no lo uso espero y resulte un buen producto alumax mexico ,
Recommended Products
