Your cart is empty.
Your cart is empty.Product Description
Lyle Briggs
Reviewed in the United States on March 4, 2025
Nice airbrush Stand an holder
Jason Niemier
Reviewed in the United States on November 16, 2024
A great stand that works well!
darkstar
Reviewed in the United States on September 9, 2023
With gravity feed airbrushes holders are a must.
Customer
Reviewed in the United States on September 14, 2022
Metal parts seem sturdy and robust enough. The yellow holders do seem like they could break eventually but I have not used them yetThe suction cups however are completely worthless. Flimsy and warped, only one corner sticks to desk
Kristyn
Reviewed in the United States on August 30, 2020
Holds my airbrushes very secure and keeps them out of the way. I haven’t dropped one out of the holder yet.I have it sitting on a table, so will most likely remove the suction cups and screw it securely to the table.
Kindle Customer
Reviewed in the United States on January 11, 2020
RECOMMEND IT OVERALL! Pros: Excellent price, metal construction parts are sturdy, the red rubber sleeve airbrush hangers grip at any angle. suction cup feet keep it anchored or can easily be bolted to workbench. metal surface easy to clean up. Holds my various Master Airbrush models as well as other brands perfectly even with vibrations of air pump right next to it. Easy to secure to any workspace surface Economical. CON: plastic airbrush nozzle holders are brittle and break easily. I knocked mine off table while set it up and the yellow plastic nozzle holder snapped. Less than 3' fall to carpet floor. Had trouble with the set screw threads and had to Loctite it.
Ricky D. Earp
Reviewed in the United States on May 28, 2019
I liked the idea of holding four airbrushes at once, and especially the ability to hold bottom feed syphon-type 'brushes. Well, that's a little problem out of the box. The "U"s covered in red-dipped vinyl, are too narrow to hold either a Badger or Paasche airbrush. A little work with a vice, and a length of 1/4"(or 1/8") galvanized pipe was the cure. There are no "instruction" other than a diagram showing how to assemble, so it isn't obvious to extend the yellow plastic nozzle holders for gravity feed 'brushes to each side for extra clearance, and to place the air line of syphon feed brushes in the middle of the "U" shaped holders for better balance. I will probably add some extra weight on the bottom of the base too, just for added stability.
Alphaorcada
Reviewed in the United States on September 17, 2018
I got this for my quicj change 4 airbrush setup. Just what I need to keep my airbrushes secure and in arms reach. I recommend also getting the quick release connects (Master Airbrush Brand Airbrush Quick Release Disconnect Coupler & Plug with Airbrush Airflow Adjustment Control Valve 1/8 in. BSP Male and Female Conn)
Recommended Products