Your cart is empty.
Your cart is empty. Our goal is to meet your needs.
Please feel free to let us know if there is any problem.
It's honored to make you satisfied.
- Model number: TES1-12704
- Voltage: 12V
- Couples: 127
- Umax (V): 15.2
- Imax (A): 4
- ΔTmax(℃)≥66
- QM(W):36.5 W
Incorporate both semiconductor technologies and electronic assembly techniques.
Do not connect the cell to a power supply for more than a few seconds without a heat-sink on the hot side otherwise there will be internal overheating and destruction of the Peltier cell.
Customer
Reviewed in the United States on March 15, 2025
Product was as stated, works great
hans haessig
Reviewed in the United States on November 18, 2024
works great
Talldogg
Reviewed in the United States on April 19, 2024
It came quickly well packaged very inexpensive
Allan J.
Reviewed in the United States on August 25, 2022
My favorite mini-fridge broke down on me. It would no longer stay cool. It was just room temperature inside. The problem was that the peltier device (the white square device pictured) no longer functioned. These are inexpensive devices, but they only last around 5 years. As you can see from the date stamp that is what happened to my mini-fridge. Fortunately, I was able to remove the back of the mini-fridge and replace the the peltier device with this device I am writing the review on and it worked perfectly. It's pretty simple to replace and does require some wire splicing. As a test you can replace the device and then turn the unit on for 3 seconds and make sure the sides are set down correctly (there is a hot side and a cool side). The cool side is placed toward the fridge and hot side is the one that goes against the heat sink. Don't forget the thermal paste when replacing this component. All in all it was a 30 minute fix and my mini-fridge is back in working order. Thanks Amazon!!!
Walt
Reviewed in the United States on October 30, 2022
Just as advertised and perfect for my application
jlourider
Reviewed in the United States on February 17, 2021
My Ecofan slowed down and finally stopped working after using for 2 years. i bought this as a replacement for the TEC and it has worked now for about two months. If you replace your TEC, use thermal grease sparingly on both sides and more important, hand-tighten the screws down as evenly as possible. Make sure that the hot and cold surfaces are parallel, then torque another half turn or so. Better to be too loose than too tight. Good luck!
MG
Reviewed in the United States on October 5, 2021
Installed it the same way the original was installed yet had reverse effects on my mini fridge, it got hot, burned out since the cooling fan was on the wrong side. My mistake but still no instructions as to which is the hot side and the cold side. If I decide to buy again I’ll test it first with low voltage.
HRP
Reviewed in the United States on August 12, 2020
Tried to repair a micro fridge with this. The first didn’t work, the replacement arrived two days later and was perfect: too hot to handle on one side, too cold to hold on the other. Unsuccessful repair, but not because of the Peltier module!
Recommended Products
$11.99
$ 6 .99 $6.99