Your cart is empty.
Your cart is empty.J.P.W
Reviewed in the United States on March 18, 2025
Survived 8 weekends of abuse at a renaissance festival completely unscathed.
Monica
Reviewed in the United States on March 14, 2025
5 stars and the company is great to work with!
Gunny
Reviewed in the United States on June 4, 2024
I served in the Marines and this type of device is called a "frog". In this case I am (was) going to use it for some Viking / Scotch dress. The belt shown (not included with the frog is 2.25 inches wide, while the throat of the belt loops are only wide enough fo maybe a 2 inch wide belt or even as narrow as 1.75 (probably much better ). Also, the actual scabbard holder must be tightly laced (included and the leather surround will not take all scabbard sizes - but probably most. Frog is riveted with bright d-rings and lace up for the actual leather to grasp the scabbard. Overall, a nice piece - BUT beware, that Viking or Scottish belt is not going to thread through the leather loops unless you take it down, remove the rivets and have that redone.
Bailey Kincaid
Reviewed in the United States on December 4, 2024
nice quality holds my sword well used it for 3 full days of renaissance shenanigans so far and hasnt failed me 10/10 reccomend
Damion Clark
Reviewed in the United States on November 4, 2024
I have a smaller scabbard, only a little more than 1 inch around, I had to readjust the strap to make it accommodate a smaller diameter. But that took me like 5 min. I like the two belt loops design.
Karin J.
Reviewed in the United States on October 9, 2024
This item is definitely NOT "Full Grain Leather" as described. It smells like plastic and you can distinctly see the textile backer or middle layer along the cut edges.
Hunter creager
Reviewed in the United States on October 2, 2024
its great but my sword keeps slipping out
Jhs1987
Reviewed in the United States on October 18, 2024
Just got this in for Halloween. Immediately attached it to a belt and put a decorative saber in it - worked. But when I went to tighten it the leather string snapped. Will likely use twin instead as it should still function but buyer beware! Otherwise looks and functions ok.
Michael Bridgeman
Reviewed in the United Kingdom on April 2, 2024
I bought this to use in conjunction with a pirate cutlass, which, being somewhat on the heavier side, needed a sturdy frog to hold it. I'm pretty impressed with the quality - and even simplicity! - of this elegant design. Riveted through 3mm leather and with a leather lace, for the money, does the job and holds the cutlass well. All I added were some brass eyelets to the lacing holes, took 5 minutes and completes the overall look. Well worth the outlay!
Robert Mckim
Reviewed in Canada on May 21, 2023
exactly as shown only wish belt loops would have accommodated for wider belt
Recommended Products
