Your cart is empty.
Your cart is empty.
Features:
The rear output is supported by bearings to improve the efficiency of the power transmission system, and is cross-drilled for use with through-pin drive shafts.
The rear output will not slide in and out, so the length of the drive shaft is easier to manage!
Specifications:
Material: Metal
Color: silver/black/red/goden/titanium
Weight: 292.7g
Suitable for: Axial AX10 SCX10 Wraith 1/10 RC Crawler Car
Package Included:
1 Pcs RC Car Gearbox
Leticia Esparza-Adame
Reviewed in the United States on March 6, 2025
Clean it out and grease it up then line the shifter rod up parallel to your frame
jacob cemenski
Reviewed in the United States on January 30, 2025
This transmission suitable for Scx10.1 and 10.2, will work on anything with the same bolt pattern on the skid. Dig works amazing. It’s well made and durable. Excellent for a trail rig, would not use for comps because it’s pretty heavy.
Daniel C.
Reviewed in the United States on September 25, 2024
So this is actually the second one of these i've gotten and use them in two different builds, and both times i've had to remove the big bulky front gear cover other than that, the transmission itself works just as it should. Easy to install the servo bracket with the supplied hardware. No instructions, though, just kind of got to figure that one out.
Caden R.
Reviewed in the United States on October 11, 2024
Top shaft has a pretty rough wobble to it. Makes it impossible to set a gear mesh
Rc guy
Reviewed in Canada on April 6, 2024
Can’t even use it with the cover on because the drive shaft hits it
Recommended Products
