Your cart is empty.
Your cart is empty.LS1 throttle position sensor TPS TP Connector Pigtail Harness Fitment for LT1 LS1 GM Vehicles
markymark
Reviewed in the United States on June 12, 2023
Had a broken pig tale. Cut and replaced. Works great.
JimmyM
Reviewed in the United States on February 22, 2023
Handy when harness does not have the correct connector. Useful for custom EFI applications.
Thurman Lucas
Reviewed in the United States on November 14, 2023
The locking tab broke off first time of plugging it in.
J Engineer
Reviewed in the United States on October 22, 2023
Perfect fit for a 99 suburban to replace a connector with corroded terminals and damaged gasket.Haven't found the cause of the misfire yet, but at least I know that this connection is now good.
Derek Hilliker
Reviewed in the United States on May 28, 2022
Fits and has long enough wires to give you some breathing room replacing the original. 5/5
Colby S
Reviewed in the United States on May 21, 2020
Worked perfectly for adding a variable TPS to my current project, pig tails are long and give you plenty of material to solder to. Plug comes with insulating/sealing ring to keep debris and water out.Will definitely buy one of these again if I need to but I think this one will last a long time under standard use.
gem hunt
Reviewed in the United States on August 7, 2019
This fit the application and is working well but wire colors were different than the application. I used it for a throttle position sensor and knew what I was doing. However, a mis-wire would have caused significant damage. Be careful! Correct wire color would have made the job easier.
K. J
Reviewed in the United States on January 24, 2018
This fits any GM pressure sensor. I used it on a 2011 crownline boat water pressure sensor with 6.2L cheby engine.
Recommended Products
