Your cart is empty.
Your cart is empty.Product Description
Random customer
Reviewed in the United States on May 11, 2024
exceeded expectations. fantastic purchase. well-made and highly functional. Will buy again
Alex H
Reviewed in the United States on December 10, 2024
Overall finish of parts is good. Polished sliding rods both run parallel and the sliding block rides them well. However the allen screw hole is not perpendicular to the block, and neither is the stop rod. See pics. While the stop rod being crooked won't affect my use, the threaded screw hole being non-square makes everything bind. Although I can get it to work I will be sending this item back. Apparently other reviewers did not have these problems...
David
Reviewed in the United States on November 19, 2024
I’ve used this vise stop on a daily basis for the last couple months. No issues and it is holding up well. Good deal for the price
MJN
Reviewed in the United States on October 12, 2024
This stop securely attaches to the vise and provides good adjustability. Great addition to my mill.
Customer Review
Reviewed in the United States on April 22, 2024
This little vise stop is really handy. It can be used in so many ways (or on so many ways...)!If you do any kind of machine work or are in the world of machining, you know what this is and what it's for and how handy it is! A jaw stop is just one of those little jigs that make repetitive jobs so much easier and faster.I know a lot of people just make these (or several) as a simple "first project" along with miniature screw jacks, but if you don't have time, this is a decent option and it works pretty well.You need to have a vise that has a little purchase on the edge of the jaw. most good milling vises should have this, but I have seen some vises that don't have much of a lip.This can also be used as a stop on your ways, again if you have the right geometry there to get clamped on to.This stop has an adjustable pin which makes it super handy for dialing it in. you don't have to move the whole clamp, just get it close and then dial in the stop with the pin. It's also good for getting clearance and keeping the stop body out of the way.Super handy gadget that will find a ton of uses in any machine shop. Hobby or pro.
Rob
Reviewed in the United States on December 4, 2023
I really like the way the part side stop fits in the jaws when machining thinner material. Overall quality is mediocre on the black parts as far as finish goes. The silver side stops are well machined. The spring load works well to spread the clamp. Regardless it fits 6" jaws very well and holds securely in place and does what it is supposed to do with repeatable results.
Melissa
Reviewed in the United States on December 31, 2023
This Mill stop is a very simple concept. I am very pleased with this new tool and it is very basic and sometimes that's better than something that is complex. It's not the greatest quality but it does the job perfectly. I would highly recommend this for any machinist.
paradug
Reviewed in the United States on November 28, 2023
I am using QZATTCAEN’s milling vise jaw stop as a lathe carriage stop for my old Atlas 6” metal lathe. For this purpose, I had to put a small shim of cork under the lower jaw to get it to fit. The shim also ensures that there is no damage to the lathe’s way. The minimum distance of the jaw spacing when it is fully tightened is 11.5mm. This is a key dimension to determine if this stop will work with your vise or other application. The offering shows dimensions but not this one, so be sure to check before ordering.The manufacturing quality of the stop is adequate. The jaws and screws have a black finish and the guides and stop bar are bright with a ground finish. The stop represents good value for the cost point.
Recommended Products
$67.99
$ 28 .99 $28.99