Your cart is empty.
Your cart is empty.Bullet Nose Carburetor Stud Kit; Carbs w/0. 5 in. Thick Flange Base w/2 in Spacer; Incl. 4 Studs/Hardnd Flat Washers/Jam Nuts;
russell krausman
Reviewed in the United States on November 6, 2024
PIC IS CHROME AND THEY SEND BLACK WASTE OF TIME NOW HAVE TO SEND THEM BACK AND ORDER FROM OTHER SELLER, THEY TRYING TO BE SNEAKY AND SEND CHEEPER BLACK INSTEAD OF CHROME
ken fischer
Reviewed in Canada on June 30, 2023
They work just fine
Caitlin
Reviewed in the United States on June 23, 2023
Moroso use to be a big deal. No it's all trash.
Cory Holbrook
Reviewed in the United States on December 15, 2022
Just like the title states. The studs were high quality, just needed some grit cleaned off the threads with a small wire brush. Had some issues with the nuts however with poorly rolled threads that wouldn’t allow the nut to properly start. Ended up using the nuts from my previous studs. They were a little different from the picture in that they had a black oxide finish instead of silver zinc or stainless but I prefer the black finish anyways
Customer
Reviewed in the United States on March 7, 2021
Black studs with washers and nuts
Stacy F.
Reviewed in the United States on April 27, 2021
Perfect length to fit my needs. Tampered top of studs makes it a lot easier to tread on the nuts.
DanGH
Reviewed in the United States on October 8, 2019
The photo used isn't correct. The photo shows chrome studs, chrome nuts, and chrome washers. What I received is black oxide studs, standard low profile nuts, and standard washers. I need them now and will use them now, but what a disappointment! One caveat, they do have a provision for safety wire if that's your need.
James M Bathgate
Reviewed in the United States on October 5, 2018
I bought these extra long studs to enable using a phenolic spacer between the carburetor and engine (hot start issues on an old truck). The specified torque for these 5/16 inch studs is 12 - 15 foot lbs. Using my torque wrench I got up to 12 ft lbs before the threads on the shaft stripped. I was using the nuts that came with the studs. Unlike the photo on Amazon, the studs appeared to be black oxide coated and not the nickel/zinc coating as shown. The quality of steel used in these is very poor and I would NOT recommend using these on your vehicle.
Kevin Merrill
Reviewed in the United States on October 4, 2016
Had previously bought carb studs from another manufacturer which were crooked. The Moroso studs were true and straight. Worked as expected.
Recommended Products
$65.00
$ 30 .99 $30.99