Your cart is empty.
Your cart is empty.Product Description
Bryan
Reviewed in the United States on February 25, 2025
I bought this knowing that it would not fit my Hawk 250 EFI model. So right away I remove all the paint, cut off the mounting bracket so I could move it by TIG welding it onto a new location. This is when I noticed how thin the metal was, maybe 18 gauge. Certainly not the "thick steel" stated in the description.I was expecting it to be thick like the mounting bracket. I did get it on the bike after powder coating it but I think it is a bit small. It is not like other brush guards I see on motorcycles that go far enough out to protect a rider's legs. I think it should be 8 inches wider and made a thicker steel, like 12 to 14 gauge.
steven brace
Reviewed in the United States on January 5, 2025
Built well , had to modify it a little bit, but honestly not a big deal at all. rps hawk 250
Randy Rucker
Reviewed in the United States on January 23, 2025
No instructions but loosen front motor mount, brackets go closest to the frame and motor mount outside. Use red locktite and torque as indicated in owners manual. Great price
Spike
Reviewed in the United States on September 2, 2024
I saw the other reviews before I purchased it, saying it wouldn’t fit, but decided to give it a try anyways because of the cheap price compared to others. When I received it, it was packaged extremely well for a crash bar so that was a plus. But as the other reviewers said, it does not fit because the brackets are the same width as the engine mounts. So what I had to do was put the brackets in a vise and bend them outwards slightly, so it would fit over the outside of the engine mounts. Then find two longer bolts that would fit through and when I tightened the bolts down it created the bend required. Now it fits and looks great and I didn’t have to spend $160 to get a little added protection.
Jellyroll Johnson
Reviewed in the United States on August 3, 2024
It's a nice addition to my Raven 250.
Christopher C.
Reviewed in the United States on July 26, 2024
The bar is made well, and the welds are good. However it doesn’t fit my bike and I specifically asked and researched to make sure it fit. Unfortunately it does not
Kevin H.
Reviewed in the United States on December 3, 2024
Remember the product description. It's for a Xpro Hawk 250. I have a CSC TT 250, so of course I had to bend the brackets a little bit. You can see how it fits though. My front fender had to be cut a little as well. But it works, if you can use your imagination a little.
D.B. Cooper 727
Reviewed in the United States on November 26, 2024
I had to re weld the tabs into correct position. The bolts that it comes with are to short.
Recommended Products
$154.99
$ 60 .99 $60.99