Your cart is empty.
Your cart is empty.Customer
Reviewed in the United States on March 11, 2025
Used for my 2018 fxbb streetbob. It fits the display great. I had to do a little grinding because it didnt fit on the 1 1/4” bars but other than that it worked perfect for me. Stays in place well while riding so far.
Philip Ali
Reviewed in the United States on September 4, 2024
Good quality and strong
FrankieLowlife
Reviewed in the United States on June 17, 2024
This product advertises it fits 1 1/4” risers. It does not. The radius for the clamps is completely off, and needed to be heavily modified and ground down with a rasp to even remotely fit. The spacing is still so far off that the clamp does not fully close, and the aluminum is so soft that when you tighten the clamp the aluminum swells where the bolts go through. I’m thoroughly dissatisfied with this product. If you’re going for a performance build, I would look to some alternative options. Just FYI the bar setup I’m running are the 13” Lucky Dave’s Lucky 13 bars, which is a popular 1 1/4” tubing one piece bar setup.
Sean C.
Reviewed in the United States on May 3, 2024
Took a chance on this item while I’m visiting America and it fits the T bars from dominator industries that I also purchased. I did a dry fit and it seems very sturdy won’t know until I install on the bike when I get back to Ireland.
David S
Reviewed in the United States on March 8, 2024
This does not fit the gap between Biltwell risers. Nice product but be advised the gap on most risers is too wide for this product.
Darrell Henry
Reviewed in the United States on November 22, 2024
Fits like it should another great product.
Brett
Reviewed in the United States on November 20, 2024
Screws do not tighten well enough to not rattle apart when riding. Entire unit rattled loose over time and half of the hardware was lost.
Recommended Products
$22.88
$ 11 .99 $11.99