Your cart is empty.
Your cart is empty.
Parameters
Model: ELF-D10
Titanium Use: Monitoring Headphone
Accessories Construction: Coaxial composite
Magnetic circuit form: Internal magnetic formula
Type: Full Range
Size: 40mm
Rated Power: 200mW
Impedance: 32 ohms
Frequency Response: 20-20,000 Hz
Sensitivity: 110 dB/W
Signal-to-Noise Ratio (SNR): 96dB
Distortion: 1% TMD
Directivity: The marked color point indicates the positive pole of the unit.
Features:
The ELF-D10 Titanium is known for its exceptional vocal and resolution performance, as well as its bass quality. It features a diaphragm coated with a special metal coating, which is not titanium or silver. The headphone accessory uses 32 ohm Japan imported black copper-clad aluminum wire and features 15.5 * 2 N45 powerful magnets with tuning adjusting paper in the middle. The tuning paper ranges from Y2-Y6, with the thinner paper providing better bass and thicker paper delivering stronger resolution.
Scott
Reviewed in the United States on June 4, 2023
The media could not be loaded.
Adum :)
Reviewed in the United States on April 6, 2023
Poor air region and too much 6k
Aaron S
Reviewed in the United States on December 30, 2021
I purchased the 50mm versions of these for my diy headphone project. Out of the box, they have zero bass, solid midrange and too much treble. but once I used my soldering iron to open two vents on the back, they warmed up significantly, and became far more balanced.For what it’s worth, I prefer the sound of these drivers in my 3D printed headphones, over the sound of my Phillips SHP 9500.
Recommended Products
