Your cart is empty.
Your cart is empty.David R
Reviewed in the United States on March 27, 2025
This was a direct fit replacement on our 1989 Yamaha Breeze 125. I was able to use existing choke and throttle cable assemblies without disconnecting them. Started up as expected.
Reviewster
Reviewed in Canada on October 20, 2024
Remove old carb. I reused the old cable attachments (throttle and choke). Install and done. Idled good right off the hop! 👍 Good throttle response. Me and my daughter are super happy!!
Evan
Reviewed in the United States on April 30, 2024
I spend 35 dollars on a carb just for it to not fit properly even though it said it was for a Yamaha breeze 125 I should have looked at the reviews then I stumbled on this one and I should have bought this one instead because it fit perfectly my Yamaha started up on the first stroke I love how they put gaskets on certain parts that need gaskets and they even coated the throttle slide just like the original carb that Yamaha made 100% recommend the only part i switched from the original was the top of the slide housing the throttle connector was a little loose which wouldn’t have caused any issues and the gasket for that was slightly thinner
Joshua Wolfe
Reviewed in the United States on April 25, 2024
I bought this for 2004 Yamaha Breeze 125. I have tried numerous carb rebuild kits and none of them had all the correct parts and the quad still would barely run. This was about the same price and so much easier. I did pull it apart and clean it before installing it. Once installed, it ran and idled without any adjustment. I increased the idle a little, but that's not an issue at all.When comparing this to the factory (original) Yamaha one, they are nearly identical, the primary difference is the markings. I would absolutely recommend this to anyone with a Breeze or Grizzly 125 as a direct replacement. The most difficult part of the installation is attaching to the throttle cable and choke to the new carb.
s burke
Reviewed in the United States on September 22, 2023
Could not get the atv to run with this new carb. Wound up cleaning the old carb really well and slapped it back on, ran perfect with the old one.
Ashleigh
Reviewed in the United States on May 8, 2023
I'm usually hesitant with non oem carbs, they seem to be hit or miss as far as quality and how well they work compared to OEM. I have a breeze that had a leaky needle seat that I planned to rebuild. My breeze had trouble idling and would cough occasionally under acceleration. But for $20 this whole carb was cheaper than a rebuild kit and based off the reviews I gave it a shot. Fit was perfect. The breeze started right up after install with no adjustments necessary. It idles perfect now and runs great under load. No more coughing, no more stalling, just riding great. Don't hesitate to buy this one.
Cheryl
Reviewed in the United States on August 7, 2022
Took very little time to put on, no problems at all. Perfect match in every way. Several other carbs say they fit the breeze but would not. I took a chance on this one and am very happy with it. Started right up and only had to adjust the idle down a little bit. I was happy to see it came with hoses, gasket and fuel filter as well that is not mentioned in the description here. Good choice!
JAKE W PARRY
Reviewed in the United States on January 3, 2022
So like a lot of others I’m sure. I bought the wrong carb for my Yamaha Breeze 125. The other option have a throttle slide that is too long. So when you install it the bike will start but it redlines right away. Then a guy on one of my groups linked me to this carb. It’s cheap but it was perfect! Bike started right up with minimal air/fuel screw to fine tune it. Runs and drives now. My daughter was super happy to finally get to ride it. It’s been a restoration project. But now it’s rideable. Thank you Zoom Zoom.
Dale t
Reviewed in Canada on May 4, 2021
Doent want to start and when it does it bogs out on acceleration
J. Gorecki
Reviewed in the United States on November 10, 2021
Works good on yamaha breeze 2004. Only thing is that when atv started cold, it tends to die. It needs a couple of minutes and then works fine. Had to adjust accelerator line as well to keep idle speed low.
Mark
Reviewed in Canada on November 7, 2019
Fits great. Choke set up very important. Just set the idle and go.
Recommended Products