Shopping Cart

Your cart is empty.

Your cart is empty.

Oil Pressure Sender, VDO Oil Pressure Sending Unit 0-10 Bar, 1/8-27 NPTF Thread Oil Pressure Sensor Sender for VDO Measurement and Control

Free shipping on orders over $29.99

$12.99

$ 5 .99 $5.99

In Stock
  • EASY INSTALLATION: The gear oil sensor Easy installation and maintain,just tighten the threads just like the original parts,the thread is 1/8-27NPTF
  • EXCELLENT PERFORMANCE: The oil pressure sender is made of high quality material, excellent workmanship, durable and long service life, reliable oil pressure part, enjoy driving, perfect replacement for the old or broken oil pressure sensor
  • WIDE APPLICABILITY: The oil pressure sensor is widely applied to many fields, such as the engine pipe of vehicle and ship, water processing project, inspection and control of industrial process, hydraulic and pneumatic control project, etc
  • PERFECT REPLACEMENT: The oil pressure sender is made by professional manufacturer, original standard, stable characteristics and excellent performance. Nice replacement for old or damaged oil pressure sensor
  • VDO MODELS: This oil pressure sensor is a very reliable hydraulic component, enjoy driving pleasure. This product is very suitable for VDO models. Replace the old or damaged oil pressure sensor well



Product Description

oil pressure sensor

Measuring Range: 0-10BAR

oil pressure sensor vdo

The above curve table shows the test results when the pressure rises:

The resistance/ohm column is a standard value, but if the detected value is within the range of positive and negative deviations, it is normal; Taking 6bar as an example, when the pressure rises from 4bar to 6bar, the standard value should be 124Ω, but if the test result is in the range of 119Ω to 129Ω, it is also normal.

skills requirement:

  1. Rated power: 0.5W; the sensor itself is passive input, but when more than 70 mA of current is input to the sensor during operation, the internal coil of the sensor will burn out!
  2. Working temperature: -25~100°C (1 hour at 120°C);
  3. Overvoltage safety: 1.5MPa (only 2 seconds for a short time);
  4. The maximum torque of the M4 nut is 1Nm;
  5. The maximum torque for installing the sensor is 30Nm;
  6. Explanation about WK: Take 360-081-030-015 as an example, the range is 0-10bar, the alarm value is 0.8bar, when the WK terminal is 10~0.8bar, WK is disconnected from the ground, and the resistance is infinite , when the oil pressure drops below 0.8bar, the WK electric contact closes, the resistance is 27 ohms, we usually call it normally closed (N.C).

oil pressure sending unit

electronic oil pressure sensor

1/8-27 oil vdo


Tacun
Reviewed in the United States on September 30, 2024
Reemplaza el vdo
Customer
Reviewed in the United States on November 22, 2024
i had to get rid of it, no good at all
being Larryied
Reviewed in the United States on October 31, 2024
used this with a VDO gauge and it worked great
Mr JB Kusner
Reviewed in the United States on October 25, 2024
works fine as expected it should
Recommended Products

$20.98

$ 10 .99 $10.99

4.4
Select Option

$31.02

$ 14 .99 $14.99

4.4
Select Option