Your cart is empty.
Your cart is empty.
OMC Cobra Sterndrive Shift Cable & Bell crank Alignment Tool
Aftermarket For Part # 915271 & 914017 / Made in USA
(Cable is not included, shown for demonstrative purposes)
This set uses the updated 7-9/16" dimension.
Made In USA From High Quality Plastic.
James Thorp
Reviewed in the United States on July 18, 2024
Nice solid tools that should last forever!!
Dennis
Reviewed in the United States on July 14, 2024
Worked just fine. Measurements were perfect.
Gerald Sawchuk
Reviewed in Canada on June 12, 2023
thank you
JamesEub
Reviewed in the United States on December 31, 2023
Fit up on my 92 OMC cobra on a reinell 20’ open bow boat as part of an entire outdrive and pivot assembly overhaul. Haven’t tried to shift yet but I assume it’ll be great.Made of thick orange plastic, durable
Ed
Reviewed in the United States on June 10, 2022
This acrylic is not strong enough to preform as tool is intended.
Jesse
Reviewed in Canada on May 17, 2021
Broke very easy, very cheap quality. Pvc would hold up better than this.
Steven linder
Reviewed in the United States on September 9, 2020
No issues!
Rob
Reviewed in the United States on December 28, 2020
Don’t buy a cheap one as I did! I bought this tool the second time. Worked great!
Mmchief
Reviewed in the United States on July 3, 2019
Don’t try to DIY shift cable without this tool. Quality product, clear material is helpful when looking and adjusting both ends of the cable
Laura
Reviewed in the United States on April 27, 2019
This tool was precise in setting the new replacement transom shift Cable for my 1989 Four Winn’s 200 Horizon OMC Cobra 5.(Ford).It saved me a lot of effort to ensure the 7 9/16” dimension setting.
Recommended Products
$109.99
$ 46 .99 $46.99